Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 2
1
2
Search: Posts Made By: 91exaccord
Showing results 1 to 25 of 33
Search took 0.85 seconds.
Forum: Honda Accord (1990 - 2002)
12-29-2004, 11:49 AM
Replies: 7
Views: 314
Posted By 91exaccord

Re: 1990 LX all fogged up!! Help!! (SpeedFreak77)

Also check that there isn't a leak getting into the car from rain water. The trunks are common to leak. As this water evaporates normally it will fog on the windows trying to excape. Make sure the...
Forum: Honda Accord (1990 - 2002)
11-18-2004, 02:53 PM
Replies: 2
Views: 421
Posted By 91exaccord

Re: Fuse location help for '91 accord (r0ckingrrl)

There isn't a fuse that runs just that light. The fuse runs all that dash lights. If it is only that light that doesn't work, it is probably burnt out. Got to take the dash apart to get to it and...
Forum: Honda Accord (1990 - 2002)
11-12-2004, 11:43 AM
Replies: 13
Views: 434
Posted By 91exaccord

Re: O2 position on header (Escobar)

The wrong type of solder can raise the resistance. I have noticed that with a few times. Buy the good stuff, it is more pure. Like they say, you get what you pay for. And since the computer could...
Forum: Honda Accord (1990 - 2002)
10-07-2004, 11:52 AM
Replies: 2
Views: 352
Posted By 91exaccord

Cam Selection

I'm just trying to get a feel for what people are running for aftermarket cams and whether they like, dislike. I have a f22a4 in a 91 ex accord. Manual, with all the bolt on goodies, no turbo. Was...
Forum: Honda Accord (1990 - 2002)
10-06-2004, 12:00 PM
Replies: 4
Views: 2,049
Posted By 91exaccord

Re: Uneven brake pad wear (Sturmcrow)

Sounds like a bad hose or caliper. The easiest way to check, which isn't alway accurate. Is to have some one step on the brake and release. Then open the bleeder and see if fluid shoots out. If...
Forum: Honda Accord (1990 - 2002)
10-01-2004, 11:44 AM
Replies: 7
Views: 362
Posted By 91exaccord

Re: (phoenixitc)

Wacko-- But ever heard of the kelly blue book? How about the local classifieds. Most people here are from all over the place. That would make a big difference in prices.
Forum: Honda Accord (1990 - 2002)
10-01-2004, 11:42 AM
Replies: 4
Views: 1,783
Posted By 91exaccord

Re: quick question, f22b2 block, obd2 obd1 (TouringAccord)

I believe that they are the same, but some of the sensors have different plug ends. Which wouldn't be hard to correct. Only real way of knowing is to set the two side by side and look.
Forum: Honda Accord (1990 - 2002)
09-29-2004, 11:48 AM
Replies: 1
Views: 328
Posted By 91exaccord

Re: Brake Light (GReddy212)

If you have the factory wing, the fuse is inline by the passenger side rear tail light. Pull that cover open in the trunk as if changing the bulb and you should see it. The light in the back window...
Forum: Honda Accord (1990 - 2002)
09-29-2004, 11:37 AM
Replies: 19
Views: 518
Posted By 91exaccord

Re: (fw190bvi)

Engine braking just means downshifting and then using the engine compressiong to assist the brakes in slowing the vehicle. Doesn't hurt the motor any, and done correctly doesn't wear the clutch...
Forum: Honda Accord (1990 - 2002)
09-27-2004, 11:45 AM
Replies: 6
Views: 583
Posted By 91exaccord

Re: (ZexyAccord)

Most likely it is the bearing. I have replaced hundreds and never have had good luck with anything but OEM. If you got it from a parts house it is most likely going out again. I think it is the...
Forum: Honda Accord (1990 - 2002)
09-22-2004, 11:49 AM
Replies: 6
Views: 13,062
Posted By 91exaccord

Re: sparkplug gap (mugenbb6)

It should be in the manual or ask the guys at the part store, its on the computer when they look up the plugs.
Forum: Honda Accord (1990 - 2002)
09-22-2004, 11:48 AM
Replies: 11
Views: 14,798
Posted By 91exaccord

Re: flywheel torque specs (prostreetonline)

If the crank stripps out before the flywheel will torque, because as your saying it is getting weak with age, I would be more afriad of it blowing apart after 150,000 miles. It weakens from constant...
Forum: Honda Accord (1990 - 2002)
09-22-2004, 11:43 AM
Replies: 27
Views: 2,000
Posted By 91exaccord

Re: (huyvu90)

How does the seat belt have anything to do with the temp?

We seem to have found the problem - Head up ass

Next fix

Some people need to have a window installed just below the belly button....
Forum: Honda Accord (1990 - 2002)
09-09-2004, 04:07 PM
Replies: 15
Views: 591
Posted By 91exaccord

Re: What the highest amount you can lower your car before a camber kit is required? (hondaracin24)

you can get the cheaper ones, but they usually end up wearing out within about a year. Depending on how you drive. With a 2 to 2.5 inch drop, you are looking at camber angles of about 4 degrees...
Forum: Honda Accord (1990 - 2002)
08-27-2004, 11:08 AM
Replies: 11
Views: 675
Posted By 91exaccord

Re: Camber Kit Problem!!!!!!! (EuRoBrO)

I had to take and drill a 3 inch hole in the upper control arm pocket to allow the arm to be moved out and still not hit the fender. then I just made a rubber cap for the hole.
Forum: Honda Accord (1990 - 2002)
08-18-2004, 12:12 PM
Replies: 5
Views: 472
Posted By 91exaccord

Re: Ecu Swaps (91exaccord)

It has the typical, header, no cat, striaght pipe w/ minimal muffler, intake, comp cam, and some suspension stuff. Still running ac, and power steering.
Forum: Honda Accord (1990 - 2002)
08-18-2004, 12:05 PM
Replies: 5
Views: 472
Posted By 91exaccord

Ecu Swaps

91 accord ex. F22A4, Looking to swap the ecu, with a better model, but not sure which to go with. Have been told to put in a b16 ecu. Any suggestions on which to go with, and how hard of a swap...
Forum: Honda Accord (1990 - 2002)
07-30-2004, 11:50 AM
Replies: 13
Views: 798
Posted By 91exaccord

Re: I cant take it anymore! (deadbymorning)

In my 91 i have the same springs, with some cutting down though. and I was getting a noise in the right rear. But I found it was the strut mount top. It has the rubber in it that holds the strut...
Forum: Honda Accord (1990 - 2002)
07-29-2004, 06:55 AM
Replies: 14
Views: 627
Posted By 91exaccord

Re: how long do MSD caps last? (ApexiChild)

Look inside the cap, if the contacts look like they got some green crystals growing. Its time to replace the cap. I have noticed with my msd stuff, the caps last about 10-15k. Really depends on...
Forum: Honda Accord (1990 - 2002)
07-21-2004, 12:16 PM
Replies: 14
Views: 524
Posted By 91exaccord

Re: CODE 12........Help locate please!!!!!!!!!!!!!!!!! (EuRoBrO)

You need the egr valve so don't just go throw it away. And the car runs different with it unpluged because the computer uses a constant value for the valve instead of what it should be reading. So...
Forum: Honda Accord (1990 - 2002)
07-20-2004, 08:54 PM
Replies: 4
Views: 513
Posted By 91exaccord

Re: oil on spark plugs. (gooberwolf)

No, it is common. It is pretty tough to get the seals around the spark plug holes to seal. A compression test wouldn't do anything because in order for it to come from the cylinder it would also...
Forum: Honda Accord (1990 - 2002)
07-20-2004, 11:52 AM
Replies: 11
Views: 442
Posted By 91exaccord

Re: accord electrical problem (foxfiretk)

You can't just pull the battery while it is running to see if the alternator is working. The ecu gets its power from the battery because it has a smoother voltage curve then the alternator output. ...
Forum: Honda Accord (1990 - 2002)
07-15-2004, 12:05 PM
Replies: 2
Views: 730
Posted By 91exaccord

Re: Removing from rotors 96 honda accord? (TURBO)

You don't have to remove the four bolts at all. First take out the cv axle. Then if you have access to a hub shark tool press the bearing out and the rotor will come with it. OR you have to use a...
Forum: Honda Accord (1990 - 2002)
07-14-2004, 12:05 PM
Replies: 6
Views: 351
Posted By 91exaccord

Re: Hot Honda (TriciaHoward)

if it doesn't over heat at an idle but only when going done the road. Have some one hold the motor at cruising rpms and check the lower radiator hose. It can get soft and actually be sucked shut by...
Forum: Honda Accord (1990 - 2002)
07-14-2004, 12:02 PM
Replies: 13
Views: 3,730
Posted By 91exaccord

Re: 91 accord sometimes wont start (cord18s)

I have had this problem too. But it wasn't in the main relay. It was the igniton module in the distributor over heating. This lead to also frying the coil. I had to replace them both and then it...
Showing results 1 to 25 of 33
 
Page 1 of 2
1
2


 
Forum Jump


All times are GMT -8. The time now is 10:37 PM.