Notices
 
Search: Posts Made By: tealbubble
Showing results 1 to 25 of 426
Search took 1.49 seconds.
01-06-2014, 03:46 AM
Replies: 5
Views: 1,956
Posted By tealbubble

Re: Missing at Low RPM

If your replacing ignition coil and icm you should go all the way and replace the inexpensive stuff. cap, rotor, wires, plugs. For a long shot you may have a clogged catalytic convertor. I've seen...
01-05-2014, 03:37 AM
Replies: 1
Views: 464
Posted By tealbubble

Re: 1995 civic manual trans problems

You might have to turn the input shaft on the trans. If you search there are answers you can find immediately. I've done plenty of transmission installs most of the time you just have to beast it or...
01-04-2014, 06:14 PM
Replies: 21
Views: 44,695
Posted By tealbubble

Re: honda manual trans fluid equivalent??

Oil works fine 10w-30 or I have had luck with Pennzoil Syncro-mesh they should sell it at any generic auto parts retailer near you.
Forum: Acura Integra
01-04-2014, 06:00 PM
Replies: 11
Views: 4,056
Posted By tealbubble

Re: Black box behind fuse panel inside cab? What is it?

It also sounds like it could be a remote starter kill. Depends on where the car has been sold before. A lot of buy here pay here dealers are able to put a box in your vehicle no matter the make or...
01-04-2014, 04:54 PM
Replies: 4
Views: 823
Posted By tealbubble

Re: 95 Civic with Y8, please help with alternator test results

Charging voltage with no load should be around 14v -14.5v. Definitely sounds like an alternator issue.

Take it off. They can also test that for free at Autozone. It just needs to be off the car to...
01-03-2014, 08:18 PM
Replies: 2
Views: 1,382
Posted By tealbubble

Re: Need help!

Is your check engine light on?

Any unusual noise coming from engine? Have you checked your coolant level? Does it immediately idle low and shut off?
Need more info
01-02-2014, 02:16 PM
Replies: 9
Views: 2,871
Posted By tealbubble

Re: Brake line fittings stuck in prop valve

I had the same problem and had to replace my lines. If you do replace them I recommend nickel copper it will never rust/rot, you can bend it by hand and it's fairly cheap in spools.
*always use...
01-01-2014, 03:23 PM
Replies: 29
Views: 3,446
Posted By tealbubble

Re: Moving North: Antifreeze Mixture and/or Oil Weight Change?

I live in Maine. The temp has been under 30 degrees for weeks now. 5W30 is what I use in my Civic and it starts easy and runs like a champ. As long as your antifreeze to water ratio is correct you...
10-24-2007, 09:03 AM
Replies: 17,417
Views: 1,031,726
Posted By tealbubble

Re: (JC VTEC)

WTB STOCK 3 LS HEAD BOLTS AND LS EXHAUST VALVE........

NEED ASAPSAAPAP
Forum: Acura Integra
10-24-2007, 02:42 AM
Replies: 3
Views: 501
Posted By tealbubble

Re: (tealbubble)

took off keepers, spring, and retainer, valve doesnt move prolly bent valve or guide same as other posts i've searched just thought i would get lucky.. guess not
Forum: Acura Integra
10-22-2007, 09:33 AM
Replies: 3
Views: 501
Posted By tealbubble

Re: (standbackimapro)

THANKS FOR THE INPUT
BUMP
10-22-2007, 05:04 AM
Replies: 17,417
Views: 1,031,726
Posted By tealbubble

Re: Re: (My1stcar_DA)

wtb

93 civic coupe ex glovebox black no pass side air bag
Forum: Acura Integra
10-22-2007, 04:54 AM
Replies: 3
Views: 501
Posted By tealbubble

VALVE STICKING OPEN AFTER MACHINE WORK Searched....

I have a 1997 b18b 80k, took off the head to get it milled and had two stripped head bolts. I had to pull the valve springs to get the easy out onto the head bolts. Lost 2 keepers, went to my...
10-07-2007, 12:37 PM
Replies: 0
Views: 340
Posted By tealbubble

South Jersey Civic Sedan on craigslist *a steal*

I saw this listing on craigslist
looks like a steal
wanted to let everyone know

http://southjersey.craigslist.....html (http://southjersey.craigslist.org/car/442028162.html)

please do not PM...
08-07-2006, 09:56 AM
Replies: 17,417
Views: 1,031,726
Posted By tealbubble

Re: (malubawla)

pmed you
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by EvilPinkEye &raquo;</TD></TR><TR><TD CLASS="quote">bump....before I call it a day

z6 or Y8...
Forum: For Sale
07-20-2006, 09:35 PM
03-14-2006, 01:26 PM
03-09-2006, 05:18 AM
03-07-2006, 03:44 PM
03-07-2006, 05:43 AM
Showing results 1 to 25 of 426
 


 
Forum Jump


All times are GMT -8. The time now is 04:21 AM.