Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 12
1
2
3
11
Last »
Search: Posts Made By: SKDRCR
Showing results 1 to 25 of 285
Search took 1.74 seconds.
Forum: Honda Civic / Del Sol (1992 - 2000)
08-24-2013, 01:37 PM
Replies: 4
Views: 641
Posted By SKDRCR

Re: 93 civic D 15 starts but then dies

indeed it was the ignition switch. you hold the key forward it will stay running once you let go it will die.
Forum: Honda Civic / Del Sol (1992 - 2000)
08-24-2013, 06:39 AM
Replies: 4
Views: 641
Posted By SKDRCR

Re: 93 civic D 15 starts but then dies

if the switch is worn out then it will think you're actually turning the key back instead of staying in the run position. haven't had a chance to check it for codes its my brothers car. I'm going...
Forum: Honda Civic / Del Sol (1992 - 2000)
08-24-2013, 05:15 AM
Replies: 4
Views: 641
Posted By SKDRCR

93 civic D 15 starts but then dies

just letting you guys input if you think this sounds like an ignition switch. I can hear the fuel pump priming and I've already checked for spark and it seems to be getting good spark. basically...
Forum: All Motor / Naturally Aspirated
05-17-2011, 02:48 PM
Replies: 82
Views: 21,952
Posted By SKDRCR

Re: ►►May-June | All Motor Classifieds | FS & WTB ◄◄

Edited now, They are H series cams. Sorry B-series guys.
Forum: All Motor / Naturally Aspirated
05-17-2011, 06:27 AM
Replies: 82
Views: 21,952
Posted By SKDRCR

Re: ►►May-June | All Motor Classifieds | FS & WTB ◄◄

H22 Skunk2 Pro1 cams for sale.
Virtually flawless condition, only around 60 miles on them.
I can send pics upon request.
$425 obo

Shoot me a pm or call 816-394-0742
Forum: Honda Prelude
05-16-2011, 01:17 PM
Replies: 106
Views: 24,763
Posted By SKDRCR

Re: ► FOR SALE ONLY ::.. NO TRIAL USERS, NO COMMENTS, NO PICTURES - Feb/Mar 2011

FS: H22 Skunk2 Pro1 cams. Virtually flawless, only 60 miles on them $425obo

Koni Yellows adjustable stiffness/Ground Control Coilovers
Great condition, comes with most hardware for them $450 ...
Forum: Engine Management and Tuning
05-12-2011, 04:49 AM
Replies: 2
Views: 739
Posted By SKDRCR

Re: Does anyone recognize what chip this is?

Just what brand chip it is.

I'll have to get a pick back up later today
Forum: Honda Prelude
05-11-2011, 06:06 PM
Replies: 16
Views: 2,130
Posted By SKDRCR

Re: Coolant issue

I would send the head to a machine shop and have them pressure test it to
make sure it's not cracked or warped as well.
Forum: Engine Management and Tuning
05-11-2011, 05:53 PM
Replies: 2
Views: 739
Posted By SKDRCR

Does anyone recognize what chip this is?

http://pictures.sprintpcs.com/mmps/016_5116b1acd8fc5786_1/2.jpg?partExt=.jpg&&&outquality=90&ext=.jpg&limitsize=615,500

This is a p28

It looks like it says EM or SM in the top left corner of...
Forum: Honda Prelude
06-17-2010, 08:56 AM
Replies: 19
Views: 2,463
Posted By SKDRCR

Re: Just purchased a 92 prelude

Check the for sale thread at the top for starters, you can find deals on all kinds
of stuff. Also you can read the FAQ's at the top as well to get a better idea on
what's a good investment and...
Forum: Honda Prelude
06-17-2010, 08:52 AM
Replies: 8
Views: 2,214
Posted By SKDRCR

Re: Humming again after bearing replacement...

Put the car on a lift and drive the vehicle to at least 35mph. Have someone listen
with a stethascope to both knuckles. See if you hear the humming noise or any
difference between both wheels. ...
Forum: Honda Prelude
10-23-2009, 02:08 PM
Replies: 10
Views: 9,336
Posted By SKDRCR

Re: Rear upper ball joints?

Awesome, thanks for the info guys :beer:
Forum: Honda Prelude
10-21-2009, 06:00 PM
Replies: 10
Views: 9,336
Posted By SKDRCR

Icon6 Rear upper ball joints?

Sup fellas :beer:

Has anybody been able to find rear upper ball joints w/o
replacing the entire control arm?

I've replaced the front uppers which they sell separate from the control arm
and...
Forum: Honda Prelude
08-21-2009, 12:10 PM
Replies: 3
Views: 1,274
Posted By SKDRCR

Re: 98 prelude over-heating?

Turn the ign. on and check the #13 fuse (15amp) in the underdash fuse/relay block.
Turn ign. off. Disconnect and ground the coolant temp sending unit guage electrical connector. Turn ign on and...
Forum: Honda Prelude
08-20-2009, 01:54 PM
Replies: 32
Views: 2,009
Posted By SKDRCR

Re: Idling Problem

Still seems like a vacuum issue to me. The little bit of play in the 6mm bolt when you
install the balance shaft belt is normal.



I'm pretty sure that is your cold start valve which raises...
Forum: Honda Prelude
08-20-2009, 01:41 PM
Replies: 6
Views: 784
Posted By SKDRCR

Re: H22a Problems

Which ecu are you using? The p28 isn't programmed to run with the 345cc
injectors of the h22a. What are you using to control the fuel?
Forum: Honda Prelude
08-20-2009, 01:33 PM
Replies: 7
Views: 974
Posted By SKDRCR

Re: CV Shaft Problem?

I haven't had too many problems with the carquest axles in honda's.

When I install them I don't hammer them in, I leave the lower ball joint
disconnected and push the spindle forward towards the...
Forum: Honda Prelude
08-20-2009, 01:27 PM
Replies: 15
Views: 54,122
Posted By SKDRCR

Re: Replaced knock sensor...still getting code 23

Try disconnecting the 2 pin connector from the knock sensor, check for continuity from the d3 pin coming out the the harness from the ecu and a good body ground.

If there is continuity repiar the...
Forum: Honda Prelude
08-20-2009, 01:17 PM
Replies: 15
Views: 54,122
Posted By SKDRCR

Re: Replaced knock sensor...still getting code 23

If the timing is too far advanced or you use too low of an octane rating on your gas
it could also probably set that code. Check the wiring from the sensor to the ecu
as well.
Forum: Honda Prelude
08-20-2009, 01:14 PM
Replies: 10
Views: 607
Posted By SKDRCR

Re: 93 h22 gettin hot on the HWY

Usually you'll see a lot of white smoke if it's your headgasket. Do a compression
test on it and see how close the psi of each cylinder is. They also make a combustion
chamber leak tester...
Forum: Honda Prelude
08-18-2009, 11:55 AM
Replies: 10
Views: 607
Posted By SKDRCR

Re: 93 h22 gettin hot on the HWY

Look at the radiator fins, is there a bunch of dirt and build up on them.
Feel the radiator hoses coming out of the radiator when it's hot, (don't burn yourself :P) and see if there is a...
Forum: All Motor / Naturally Aspirated
07-24-2009, 02:25 PM
Replies: 214
Views: 52,583
Posted By SKDRCR

Re: H22 N/A rebuild...Good setup??

You'll wanna upgrade the valvetrain if you run the pro1 cams.

I have these cams, and I'm going with a Supertech valvetrain as well as flat
faced valves and s2 cam gears when I get the money...
Forum: Honda Prelude
07-24-2009, 02:14 PM
Replies: 4
Views: 1,623
Posted By SKDRCR

Re: 93 Si, Removing Intake Manifold Problems *searched extensively

Mark all of your vacuum lines or make sure your routing diagrahm sticker is still
on the hood. Remove air intake, throttle/cruise cables, fuel connection to fuel rail,
wiring harness from misc....
Forum: Honda Prelude
05-20-2009, 10:19 AM
Replies: 30
Views: 1,638
Posted By SKDRCR

Re: H22 Experts Help

You can run a ground wire from the valve cover to the drivers
side motor mount bracket.
Forum: Honda Prelude
05-20-2009, 09:45 AM
Replies: 6
Views: 3,137
Posted By SKDRCR

Re: Turbocharged RWD H22

There was also a guy on here who swapped an ls1 into a 4th gen.

Edit: found it :beer:
https://honda-tech.com/forums/showthread.php?t=1645997

Damn, I guess Rocktman never finished it :(
Showing results 1 to 25 of 285
 
Page 1 of 12
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 06:01 PM.