Honda-Tech - Honda Forum Discussion

Notices
Search: Posts Made By: racingrex
Showing results 1 to 18 of 18
Search took 0.99 seconds.
Forum: Acura Integra
07-18-2007, 10:24 PM
Replies: 6
Views: 15,366
Posted By racingrex

Re: Oil light flickers, comes on dimly, intermittently (Sam92Teg)

my car also has quite a few miles on it 255k.

I replaced the oil pressure sender unit thingy, it was cheap and easy so I thought what the hey, could be an easy fix. Anyway, it wasn't. I replaced...
Forum: Acura Integra
07-18-2007, 03:13 PM
Replies: 6
Views: 15,366
Posted By racingrex

Re: Oil light flickers, comes on dimly, intermittently (lovemyintegra1)

Update:

Oil light went to full bore flash on and off indicating, to quote the owners manual "a severe loss of oil pressure"

does this mean oil pump? or is there anything else in there?
...
Forum: Acura Integra
07-18-2007, 08:24 AM
Replies: 6
Views: 15,366
Posted By racingrex

Oil light flickers, comes on dimly, intermittently

I have a stock 1990 integra LS 4 dr. after some spirited driving yesterday I noticed the oil light on the gauge cluster came on. It seems like it is not fully lit, like its not as bright as when...
Forum: Honda Civic / Del Sol (1992 - 2000)
12-26-2005, 01:56 PM
Replies: 0
Views: 308
Posted By racingrex

help, 96 civic valve tap

i have 96 civic cx with d16y7 and a valve has been tapping. i searched and found how to adjust the valves, i went through all that and every thing seemed to be to spec. after i put everything back...
Forum: Honda Civic / Del Sol (1992 - 2000)
07-29-2004, 12:09 AM
Replies: 5
Views: 4,856
Posted By racingrex

Re: 96 civic oil pan d16y7 leaks...HELP! (racingrex)

Welp I got a new gasket so I'll be attempting it again, any more suggestions out there 'fore I get started, thanks.
Forum: Honda Civic / Del Sol (1992 - 2000)
07-18-2004, 06:54 PM
Replies: 5
Views: 4,856
Posted By racingrex

96 civic oil pan d16y7 leaks...HELP!

I had a fairly slow leak coming from the oilpan gasket so i replaced the gasket and and it still leaks, more than before. I didnt have a torque wrench at the time so i kinda winged it, most likely...
Forum: Honda CRX / EF Civic (1988 - 1991)
11-14-2003, 03:12 PM
Replies: 5
Views: 2,763
Posted By racingrex

spun cam bearing? worth my time/work?

i have a 84 crx with bad motor, and looking at another 84 for really cheap. the problem is it has a spun cam bearing . i dont know what this is, and what it entails(easy to fix, cheap to fix and...
Forum: Honda Civic / Del Sol (1992 - 2000)
11-09-2003, 05:44 PM
Replies: 0
Views: 724
Posted By racingrex

96 civic cx engine code 67?

I have a 96 hatch, d16y7, and it started throwing engine code 67, which turns out to be: "Catalyst system Efficiency Below Threshold malfunctioning or defective catalyst system," i was just...
Forum: Honda CRX / EF Civic (1988 - 1991)
11-06-2003, 04:46 PM
Replies: 7
Views: 1,982
Posted By racingrex

Re: really hard to start really rough idle (mntuner2)

alrighty, so i go out to my car this evening and check the oil and its really full, and it seems to be gasoline mixed with the oil and there is also a slick on my carport floor that seems to be a...
Forum: Honda CRX / EF Civic (1988 - 1991)
11-04-2003, 06:30 PM
Replies: 7
Views: 1,982
Posted By racingrex

Re: really hard to start really rough idle (mntuner2)

hmm yeah, pulled and checked all the plugs, cleaned em up and regapped em, also i checked cap and rotor, all seemed to be good, plug wires are about 1.5 years old, wouldnt think itd be them. coil...
Forum: Honda CRX / EF Civic (1988 - 1991)
11-03-2003, 02:50 PM
Replies: 7
Views: 1,982
Posted By racingrex

Re: really hard to start really rough idle (racingrex)

another bump / update. I replaced the mecahnical fuel pump, didnt do anything, same problem. For the love of all that is good somebody please help me....
Forum: Honda CRX / EF Civic (1988 - 1991)
10-28-2003, 09:14 PM
Replies: 7
Views: 1,982
Posted By racingrex

Re: really hard to start really rough idle (racingrex)

Bump / Update. I replaced the in-bay fuel filter, car started fine after that and ran well for a while. I shut the car off and left for a while; when I came back it was tough to start and had the...
Forum: Honda CRX / EF Civic (1988 - 1991)
10-27-2003, 10:33 PM
Replies: 2
Views: 322
Posted By racingrex

Re: Replacing Wheel Bearings????? (Mr. S)

It is the front, driver's side I believe, but front for sure

I was told by a collegaue at work that I had to take off the entire strut and disconnect the steering rack, and sway bar, and take the...
Forum: Honda CRX / EF Civic (1988 - 1991)
10-27-2003, 10:08 PM
Replies: 2
Views: 322
Posted By racingrex

Replacing Wheel Bearings?????

My car has been making humming or whirring noises at higher speeds, it seems to be originating from the wheel area, I've been told from other posts (as well as a mechanic) that it is probably my...
Forum: Honda CRX / EF Civic (1988 - 1991)
10-27-2003, 10:01 PM
Replies: 7
Views: 1,982
Posted By racingrex

really hard to start really rough idle

I have an 84 crx with an EW1 engine, carbuerated, and today I tried to start it after class today and it cranks and fires but it doesnt seem like its getting fuel to the cylinder. I can sit there...
Forum: Honda CRX / EF Civic (1988 - 1991)
04-01-2003, 01:38 PM
Replies: 5
Views: 512
Posted By racingrex

Re: 84 (racingrex)

sorry, bad link, i didnt know what i was doing, the rims really look like this

http://www.we-todd-did-racing.com/wetoddimage.wtdr/i=wNzkxODA2czQxM2RmZDMxeTU0MQ%3D%3D
Forum: Honda CRX / EF Civic (1988 - 1991)
04-01-2003, 01:24 PM
Replies: 5
Views: 512
Posted By racingrex

Re: 84 (crxfanatic)

the rims i have look like this

C:\documents and settings\administrator\desktop\crx wheel.jpeg

sorry for the bad pic, its just one i had around
Forum: Honda CRX / EF Civic (1988 - 1991)
03-30-2003, 09:10 PM
Replies: 5
Views: 512
Posted By racingrex

84 (first gen) crx rims

I have an 84 crx with three rims that match, but i have only ever seen this type of rim once before and it was in a sport compact car article. They are, I think, aluminum alloy four-spokes and they...
Showing results 1 to 18 of 18


 
Forum Jump


All times are GMT -8. The time now is 10:50 PM.