Notices
 
Search: Posts Made By: djfob
Showing results 1 to 25 of 184
Search took 1.14 seconds.
06-14-2013, 09:43 PM
Replies: 2
Views: 882
Posted By djfob

That would make sense, I'll look for a z6 tab to...

That would make sense, I'll look for a z6 tab to try.
06-14-2013, 10:55 AM
Replies: 2
Views: 882
Posted By djfob

idle drops low in neutral only when cold

99 civic ex with a obd1 d16 swap. When motor is cold when you rev it or step on the clutch to neutral, idle drops to 200 and sometimes dies. Idle from this point will go back up to 1500 rpm but not...
06-06-2013, 05:35 PM
Replies: 2
Views: 764
Posted By djfob

Re: stumped! 99 ex intermittent stall while driving

Just one for knock sensor. Had this cel for years since I don't run one.

Also have a car starter installed, not sure if that could be an issue.
06-06-2013, 05:16 PM
Replies: 2
Views: 764
Posted By djfob

stumped! 99 ex intermittent stall while driving

Once in a while car will just lose power and stall while I'm driving, won't start right away either. Also accompanied by a burning smell. Earlier today it would hesitate going uphill in 2nd gear,...
Forum: Acura Integra
04-06-2012, 04:44 PM
Replies: 16
Views: 77,698
Posted By djfob

Re: Coolant temp gauge stays cold

It was probably 30F out today. Heat warmed up after 10 min of driving which seems normal. I can basically idle my car up to normal operating temp no prob. Once I start driving for say 15 min...
Forum: Acura Integra
04-06-2012, 01:47 PM
Replies: 16
Views: 77,698
Posted By djfob

Re: Coolant temp gauge stays cold

heat still works fine
Forum: Acura Integra
04-06-2012, 11:42 AM
Replies: 16
Views: 77,698
Posted By djfob

Coolant temp gauge stays cold

When I'm driving coolant temp gauge hovers either below or just above cold. Idle is also a bit high at around 1100. Now when I'm just idling for a 5 minutes or so, the temp gauge starts to go up to...
12-06-2011, 02:56 PM
Replies: 1
Views: 2,688
Posted By djfob

Groove on crank from rear main seal

So I my motor was puking oil from the rear main, after pulling it out I saw a groove on the crank. I've done some searching and I found seating the new seal on a fresh part of the crank would fix it....
12-01-2011, 07:11 PM
Replies: 8
Views: 4,691
Posted By djfob

Re: Hondabond 4 on rear main seal housing

I didn't want to risk scratching the crank with a screwdriver, tried threading a screw into the seal but couldn't pull it out that way.
12-01-2011, 06:30 PM
Replies: 8
Views: 4,691
Posted By djfob

Re: Hondabond 4 on rear main seal housing

Yeah the rear main seal I just used motor oil, the sealant is for the rear main housing. I had to remove to to get the seal out.
12-01-2011, 05:52 PM
Replies: 8
Views: 4,691
Posted By djfob

Hondabond 4 on rear main seal housing

I can't find hondabond ht locally but I have a tube of hondabond 4. Will 4 work just fine to mate the rear main seal housing to the block. I've read somewhere that its not meant to be used on...
11-16-2010, 10:39 PM
Replies: 2
Views: 5,772
Posted By djfob

Re: 02 V6 Accord Center Bore Size

that's where I got my 70.3 but I've seen 64.1 posted on some forums
11-16-2010, 09:25 PM
Replies: 2
Views: 5,772
Posted By djfob

02 V6 Accord Center Bore Size

While searching I've found out that's it either 64.1 or 70.3. Hopefully someone here can give me a definate answer. Thanks in advance.
08-18-2010, 07:43 PM
Replies: 6
Views: 2,529
Posted By djfob

Re: Moates burn2 chip burner, chipped ecu

What ecu is it? Can I get a pic of the zif?
08-04-2010, 03:33 PM
Replies: 7
Views: 1,238
Posted By djfob

Re: B series Turbo Manifold $75, GSR P72 OBD2 ECU $75

pics of manifold? a/c and p/s friendly?
03-21-2010, 10:39 AM
Replies: 0
Views: 1,457
Posted By djfob

Brakes groan

When I brake hard the driver side brakes makes a groan sound. Pedal feels fine and no groaning under any conditions other than hard braking. Thinking it could be something with the abs? the pads were...
10-22-2009, 10:31 PM
Replies: 1
Views: 2,245
Posted By djfob

B16a will only start on second try when cold

So I am trying to diagnose a problem with my newly replaced b16a, I bent valves on the previous b16. When the engine is cold it will never start on the first try, but will always catch on the second...
Forum: Want to Buy
10-20-2009, 03:57 PM
Replies: 4
Views: 464
Posted By djfob

WTB: 90-93 integra catalytic converter

Let me know what you have and how much shipped to Canada T3K 3P6. Thanks
Forum: For Sale
10-20-2009, 03:42 PM
Forum: Want to Buy
09-13-2006, 02:58 PM
Replies: 8
Views: 300
Posted By djfob

bump

bump
Forum: Want to Buy
09-11-2006, 05:09 PM
Replies: 8
Views: 300
Posted By djfob

bump.....someone must have a white one

bump.....someone must have a white one
Forum: Acura Integra
09-11-2006, 01:30 PM
Replies: 6
Views: 659
Posted By djfob

Question about 94-01 teg oem spring/shocks

One of my oem springs rusted out and broke, I'm just looking for an oem spring to replace it since its just my winter car. Question is do all DCs use the same spring/shocks other than the type r?...
Forum: Want to Buy
09-04-2006, 05:11 PM
Replies: 8
Views: 300
Posted By djfob

Re: WTB: 94+ oem spoiler (srt42004n)

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by srt42004n &raquo;</TD></TR><TR><TD CLASS="quote">pm'd ...
Forum: Want to Buy
09-03-2006, 07:56 PM
Replies: 8
Views: 300
Posted By djfob

WTB: 94+ oem spoiler

it's worth a shot but I'd prefer white..............
08-03-2006, 06:26 PM
Replies: 12
Views: 1,954
Posted By djfob

Re: 96 Coupe EX with 99-00 Si Stock Exhaust? (djfob)

Just swapped it onto my 94 ex and it fits well other than having to remove the heatshoelds. It also hits my shifter a bit but nothing a grinder won't fix.
Showing results 1 to 25 of 184
 


 
Forum Jump


All times are GMT -8. The time now is 10:26 PM.