Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: JUNlemonPrelude
Showing results 1 to 25 of 117
Search took 0.97 seconds.
Forum: Honda Prelude
03-29-2011, 08:22 PM
Replies: 8
Views: 848
Posted By JUNlemonPrelude

Re: 1995 honda prelude question

I dont know where you live, but if you have access to a junkyard in your town grab another line just in case. From the looks and questions of it, sounds like your doing a full build or tearing the...
Forum: Honda Prelude
03-29-2011, 08:19 PM
Replies: 29
Views: 58,897
Posted By JUNlemonPrelude

Re: 4th gen. radiator fan stays on after car is off?

Its normal, thats why you have ECT sensor for the fan. if your radiator is not getting the correct airflow to lower the coolant temperature. your fans should come on at a specific temperature. When...
Forum: Honda Prelude
03-29-2011, 08:07 PM
Replies: 8
Views: 848
Posted By JUNlemonPrelude

Re: 1995 honda prelude question

just gotta be careful when removing them. there torque down pretty good.
Forum: Honda Prelude
03-29-2011, 08:00 PM
Replies: 10
Views: 1,033
Posted By JUNlemonPrelude

Re: bad wiring please heeelp

Buy a new wiring harness for a 5spd model. Or have some patience and go thru each harness 1 by 1.
Forum: Honda Prelude
03-29-2011, 07:57 PM
Replies: 8
Views: 848
Posted By JUNlemonPrelude

Re: 1995 honda prelude question

very hard to have a coolant leak there unless the the lines/fittings are damaged.
Forum: Honda Prelude
03-27-2011, 09:32 PM
Replies: 43
Views: 12,016
Posted By JUNlemonPrelude

Re: Can't pass smog!

Yeah i know that, i read and see some videos on youtube and drilling the ports. And for the timing i think they thought 14˚ was dead on. I didnt care too much, it pass and now cops cant pull me over...
Forum: Honda Prelude
03-27-2011, 09:21 PM
Replies: 7
Views: 3,709
Posted By JUNlemonPrelude

Re: H22a1 93' Running Issues - Not sure could be misfire/bogging and cuts out.

sounds like you have some vacuum leaks, causing those codes. idling surging up and down is the FITV. I Believed thats the one, it uses the coolant to regulate your rpms when you first start your...
Forum: Honda Prelude
03-26-2011, 07:26 PM
Replies: 43
Views: 12,016
Posted By JUNlemonPrelude

Re: Can't pass smog!

It was at 15˚BTDC, which is the factory specs +/- 2˚
Forum: Honda Prelude
03-26-2011, 02:25 PM
Replies: 43
Views: 12,016
Posted By JUNlemonPrelude

Re: Can't pass smog!

I had my buddys mechanic work on it. they did the same thing i did, just tore my EGR valve and intake manifold apart. Clean the shit out of it more and they got it to pass. took them a while to...
Forum: Honda Prelude
03-26-2011, 02:19 PM
Replies: 7
Views: 11,257
Posted By JUNlemonPrelude

Re: Help with CEL code 12 - EGR

It seems like everyone lately is gettiing DTC 12. That was the major player in my emissions test failure. I got a 95 prelude si-vtec, my egr valve was stuck. Make sure you clean it thoroughly. it...
Forum: Honda Prelude
03-23-2011, 08:17 AM
Replies: 43
Views: 12,016
Posted By JUNlemonPrelude

Re: Can't pass smog!

Will that affect it during the test? Heard of other people putting alcohol fuel becuase it burns cooler. Unfortunately EGR valve didn't help. Now it fails. Getting a new EGR valve today.
Forum: Honda Prelude
03-22-2011, 09:21 PM
Replies: 21
Views: 12,360
Posted By JUNlemonPrelude

Re: need distributor advice: jdm h22

did you plug each spark plug wire in the correct position? Rough idling and misfire can be your MAP sensor, TDC/CKP/CYP senor and fuel injectors. Top Dead Center (TDC) Crankshaft Position sensor...
Forum: Honda Prelude
03-22-2011, 08:55 PM
Replies: 9
Views: 6,443
Posted By JUNlemonPrelude

Re: honda prelude electrical problems

Download the manual, have a friend or someone help you also. Someone to rev the engine at different rpms to test the load and output. Using a multimeter should be fine.
Forum: Honda Prelude
03-22-2011, 08:30 PM
Replies: 8
Views: 10,083
Posted By JUNlemonPrelude

Re: Drilling Intake Runners (EGR Ports)

A lot of people have been doing this, but I just took the extra time to remove the intake manifold and spray carb cleaner in the EGR ports until full. let it sit up for about 5 minutes and dump it...
Forum: Honda Prelude
03-22-2011, 08:27 PM
Replies: 43
Views: 12,016
Posted By JUNlemonPrelude

Re: Can't pass smog!

Bit the bullet and put a new O2 sensor in and then a new cat. Failed the 15mph test and pass the 25mph test. What else can cause high levels of NOx, timing is dead on to factory specs. no leaks in...
Forum: Honda Prelude
03-19-2011, 08:05 PM
Replies: 43
Views: 12,016
Posted By JUNlemonPrelude

Re: Can't pass smog!

Taking out and cleaning the intake manifold and EGR ports was a must. My intake manifold was cleaner than i thought but the EGR ports were f'king dirty and gunk up. I used 2 and half cans of carb...
Forum: Honda Prelude
03-19-2011, 08:42 AM
Replies: 43
Views: 12,016
Posted By JUNlemonPrelude

Re: Can't pass smog!

Im actually gonna work on the cooling system today. Drain and replace the coolant/thermostat and the sensors. Had my fan switch sensor replace about 4 months ago. My timing is good. but i'll make...
Forum: Honda Prelude
03-18-2011, 07:08 PM
Replies: 43
Views: 12,016
Posted By JUNlemonPrelude

Re: Can't pass smog!

Failing all now. Tremendously 4 times the limit on each category.
Forum: Honda Prelude
03-18-2011, 06:47 AM
Replies: 5
Views: 1,729
Posted By JUNlemonPrelude

Re: 4th Gen Clutch Problems

Check the bleeder valve. Mine was new but it was bad, didnt seal properly. Have someone pump the clutch while you watch it to see any small leaks. Pump and hold it down, thats how i found the small...
Forum: Honda Prelude
03-17-2011, 07:15 PM
Replies: 43
Views: 12,016
Posted By JUNlemonPrelude

Re: Can't pass smog!

Im having the same f'king problem. The last two smog test i passed (Last 4 years) and had my cat replace and all. Now my recent smog this feb, I failed. I replaced the EGR solenoid valve today, and...
Forum: Honda Prelude
01-03-2011, 08:52 PM
Replies: 5
Views: 1,729
Posted By JUNlemonPrelude

Re: 4th Gen Clutch Problems

No doubt. I'll definitely check that area out again. Finally got pressure back up. The new slave cylinder bleeder valve was leaking. Grabbed the old one and put that in place. And DAMN.... Took...
Forum: Honda Prelude
01-02-2011, 03:52 PM
Replies: 5
Views: 1,729
Posted By JUNlemonPrelude

4th Gen Clutch Problems

I have changed my clutch master cylinder quite a few times already. And the problem still persist. I'd notice every so often, 2-4 months my clutch reservoir would be empty. Theres no leaks around...
Forum: Honda Prelude
10-16-2010, 10:02 PM
Replies: 16
Views: 11,766
Posted By JUNlemonPrelude

Re: 92 Prelude No Start, fuel issue?

did u put everything back in place? TDC etc? sounds way too familar. its not grounded correctly. did a rebuild on a h22/h23 engine. same thing happen. it was a grounding issue and previous owner ran...
Forum: Honda Prelude
10-14-2010, 08:52 PM
Replies: 13
Views: 2,293
Posted By JUNlemonPrelude

Re: Master cylinder leak.

brake master cylinder or clutch master cylinder?
Forum: Honda Prelude
10-14-2010, 08:50 PM
Replies: 5
Views: 1,070
Posted By JUNlemonPrelude

Re: Replace or adjust valves?

valve adjustment. When adjusting your valves make sure your engine is cold or air temp. use a feeler gauge and specs for your model.
Showing results 1 to 25 of 117
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump


All times are GMT -8. The time now is 03:22 PM.