Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: driftin4
Showing results 1 to 25 of 106
Search took 1.04 seconds.
Forum: Honda Civic / Del Sol (1992 - 2000)
04-29-2010, 01:19 PM
Replies: 13
Views: 1,431
Posted By driftin4

Re: HELP!!!!! swap done car wont start

Since you have fuel pressure and spark, you need to figure out why you don't have injection pulse (assuming that you don't).
Forum: Honda Civic / Del Sol (1992 - 2000)
04-29-2010, 01:16 PM
Replies: 13
Views: 1,431
Posted By driftin4

Re: HELP!!!!! swap done car wont start

I would be inclined to figure out if you are missing injector pulse or fuel.
Forum: Suspension & Brakes
04-21-2010, 02:40 PM
Replies: 4
Views: 3,062
Posted By driftin4

Re: h&r coilover spring rate

Get pics for sure, but what you are describing is ID springs and based on the numbers, they are 250mm in length and 50nm (285lbs) 40nm (228lbs).
Forum: Suspension & Brakes
04-21-2010, 07:08 AM
Replies: 4
Views: 3,062
Posted By driftin4

Re: h&r coilover spring rate

If it's the 29808 kit with the original springs on it, it should be 345 front and 230 rear.
Forum: Honda Civic / Del Sol (1992 - 2000)
04-20-2010, 04:02 PM
Replies: 28
Views: 60,199
Posted By driftin4

Re: Pistons and rings without pulling the motor?

So you are telling me that you regularly see cylinder ridges in honda motors?? Well, I guess you must have seen far more honda motors than I did as a honda master tech..
Forum: Honda Civic / Del Sol (1992 - 2000)
04-20-2010, 03:55 PM
Replies: 28
Views: 60,199
Posted By driftin4

Re: Pistons and rings without pulling the motor?

Tell me the last time you saw a cylinder ridge in a honda engine???
Forum: Honda Civic / Del Sol (1992 - 2000)
04-20-2010, 03:12 PM
Replies: 7
Views: 4,531
Posted By driftin4

Re: Crazy Overheating problem on a 93 civic

Compression tests can be a little misleading at times when diagnosing a head gasket issue. Best thing is if you can get your hands on a Co2 test setup. You essentially just pull the vapor from the...
Forum: Honda Civic / Del Sol (1992 - 2000)
04-20-2010, 03:00 PM
Replies: 7
Views: 4,531
Posted By driftin4

Re: Crazy Overheating problem on a 93 civic

Any oil in the coolant overflow bottle?
Forum: Honda Civic / Del Sol (1992 - 2000)
04-20-2010, 02:55 PM
Replies: 28
Views: 60,199
Posted By driftin4

Re: Pistons and rings without pulling the motor?

I have done countless in-chassis rebuilds on Honda motors, and I really mean countless. Unless building a race engine, there is rarely a reason to bore or replace main/thrust bearings, both surfaces...
Forum: Honda Civic / Del Sol (1992 - 2000)
04-20-2010, 02:28 PM
Replies: 26
Views: 6,593
Posted By driftin4

Re: 5 speed only shifts with engine off?!

Very likely. Simple to bleed, just do it like you are doing brakes.
Forum: Honda Civic / Del Sol (1992 - 2000)
04-20-2010, 02:27 PM
Replies: 2,032
Views: 181,527
Posted By driftin4

Re: "You know you own an EG, EK when ..."

When your friends know you make decent money but just don't get why you still choose to drive the econobox..
Forum: Honda Civic / Del Sol (1992 - 2000)
04-20-2010, 02:22 PM
Replies: 26
Views: 6,593
Posted By driftin4

Re: 5 speed only shifts with engine off?!

If it were that loose, it would likely make some noise too.

A couple of things are the most likely issues. Number 1 being the possibility of air in your slave cylinder. When you pulled things...
Forum: Honda Civic / Del Sol (1992 - 2000)
04-20-2010, 02:07 PM
Replies: 26
Views: 6,593
Posted By driftin4

Re: 5 speed only shifts with engine off?!

Over tightening the pressure plate bolts will do nothing more than fatigue the bolts, it will have absolutely nothing to do with the operation of the pressure plate.
Forum: Honda Fit
04-20-2010, 01:51 PM
Replies: 503
Views: 236,279
Posted By driftin4

DC Sports Ceramic Header

NIB (as in never opened) DC Sports part # HHC5023

$200.00 shipped to the continental US.
Forum: Suspension & Brakes
04-20-2010, 12:55 PM
Replies: 24
Views: 2,885
Posted By driftin4

Re: crazy problem w slammed car

If the ball joint were bent, I could see it happening, but it would have to be seriously bent and causing the control arm to offset toward the rotor.
Forum: Honda Accord (1990 - 2002)
11-24-2009, 12:14 PM
Replies: 8
Views: 3,519
Posted By driftin4

Re: Suspension bump stop question!

Follow the lowering spring manufacturers guidelines for your car!
Forum: Honda CRX / EF Civic (1988 - 1991)
12-07-2007, 11:18 AM
Replies: 27
Views: 761
Posted By driftin4

Re: (Si-Samuri)

If it feels out of balance, and you are not just being over sensitive because you "believe" there is a problem, then I would recheck the install. Make sure the springs are sitting properly in their...
Forum: Honda CRX / EF Civic (1988 - 1991)
12-07-2007, 09:54 AM
Replies: 10
Views: 5,100
Posted By driftin4

I have towed ton's of times with EF9's! I tried a...

I have towed ton's of times with EF9's! I tried a boat like above once, just cause I needed to move it a few blocks, I turned around a block into it because I was afraid of what I was doing to the...
Forum: Honda CRX / EF Civic (1988 - 1991)
12-07-2007, 08:51 AM
Replies: 27
Views: 761
Posted By driftin4

So the only one rear corner is out but the front...

So the only one rear corner is out but the front is exactly the same on both sides? If you tilt one corner of a box down, the opposite corner is going to raise, so if the opposite corner is not a...
Forum: Road Racing / Autocross & Time Attack
05-29-2004, 03:22 PM
Replies: 58
Views: 1,198
Posted By driftin4

Re: 4 pt. "cage" (JoesTypeS)

One of the nicer looking bolt-ins I have seen! https://honda-tech.com/forums/images/smilies/emthup.gif
Forum: Road Racing / Autocross & Time Attack
05-28-2004, 05:08 PM
Replies: 13
Views: 1,991
Posted By driftin4

Re: (martini)

Yeah, Dryad is another wash at this point... http://images.honda-tech.com/set1//smile/emcrook.gif

So did the leak down checker help this time?
Forum: Road Racing / Autocross & Time Attack
05-28-2004, 01:28 PM
Replies: 13
Views: 1,991
Posted By driftin4

Pictures of "The Replacement" and a long story on what lead up to it....

Well for those who do not know me, I am a car geek! Yeah, join the club right....

I started SCCA Rally last season with a 90 SI and we did very well together!!

She (The Mighty Civic) can even...
Forum: Road Racing / Autocross & Time Attack
05-28-2004, 10:25 AM
Replies: 17
Views: 1,284
Posted By driftin4

Re: (Andrie)

https://honda-tech.com/forums/images/smilies/emthup.gif

Need any suspension stuff https://honda-tech.com/forums/images/smilies/emwink.gif
Forum: Road Racing / Autocross & Time Attack
05-28-2004, 10:07 AM
Replies: 17
Views: 1,284
Posted By driftin4

Re: (Andrie)

Damn that would be perfect for my rally car!!

Hmmm, gonna have to see what I can do!
Forum: Road Racing / Autocross & Time Attack
05-28-2004, 09:07 AM
Replies: 6
Views: 684
Posted By driftin4

Re: Roll cage question (travis)

Travis, I say the following with the utmost respect to you. Seriously!!

But your cage scares the hell outa me..

You have fabulous side protection and your barrel roll protection is adequate but...
Showing results 1 to 25 of 106
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump


All times are GMT -8. The time now is 06:00 PM.