Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: v4lu3s
Showing results 1 to 25 of 492
Search took 1.23 seconds.
Forum: Honda CRX / EF Civic (1988 - 1991)
12-04-2019, 11:56 AM
Replies: 10
Views: 10,775
Posted By v4lu3s

Re: SOHC ZC; which distributor

Obd1 non vtec distributor is what i used
Forum: Honda CRX / EF Civic (1988 - 1991)
07-19-2018, 05:53 PM
Replies: 4
Views: 2,226
Posted By v4lu3s

Re: Trailing arm swap

I just swapped the disc brake assemblies on to my trailing arms and put new trailing arm bushings in at the same time as well as the other bushings. was a lot easier than trying to put the whole arm...
Forum: Honda CRX / EF Civic (1988 - 1991)
07-06-2018, 08:48 PM
Replies: 11
Views: 1,076
Posted By v4lu3s

Re: Drop springs didn't drop lol

are you sure they are springs for a CRX?
Forum: Honda CRX / EF Civic (1988 - 1991)
07-06-2018, 08:47 PM
Replies: 3
Views: 1,238
Posted By v4lu3s

Re: Help with obd0 ecu code

if the 16 and 20 repeat over and over I would think it is code 16 and 20, and time to get out the service manual and run the troubleshooting steps in there...or hire a mechanic to do that for you.
Forum: Tech / Misc
05-29-2018, 08:03 PM
Replies: 8
Views: 3,050
Posted By v4lu3s

Re: Assitance Needed: 1990 B16A3 "Missing Data Link Connector"

what state and standard is your test done to? afaik there was no data link connector until 1996 when obd 2 became standard. I could be wrong, but I am not familiar at all despite having worked on...
Forum: Honda CRX / EF Civic (1988 - 1991)
05-01-2018, 06:09 AM
Replies: 7
Views: 4,417
Posted By v4lu3s

To those using aftermarket steering wheels

After many years my original steering wheel from 1989 was crap, I swapped a better one from another 89 CRX. it is now also going to crap.
I am looking at after market steering wheels and would...
Forum: Suspension & Brakes
04-02-2018, 04:47 AM
Replies: 14
Views: 2,046
Posted By v4lu3s

Re: Any experience with these coilovers?

Progress CS2
Forum: Honda CRX / EF Civic (1988 - 1991)
02-26-2018, 06:46 PM
Replies: 1
Views: 520
Posted By v4lu3s

Re: Will mechanical timing effect smog results? d16a6

it needs to be set to stock for stock emissions. that means mechanical timing and ignition timing. if it is not meeting emissions like that then you need to look at other things.
Forum: Honda CRX / EF Civic (1988 - 1991)
02-26-2018, 06:41 PM
Replies: 6
Views: 3,176
Posted By v4lu3s

Re: Under dash wiring...

my car has an obd2 engine harness, obd1 ecu and is an 89. I left as much of the original wiring under the dash as possible because I cannot be certain what I do and do not need. In fact it took a...
Forum: Honda CRX / EF Civic (1988 - 1991)
02-26-2018, 06:37 PM
Replies: 20
Views: 5,696
Posted By v4lu3s

Re: 1987 CRX si problems... help!

are you talking about the block or the head? the head could be swapped from a later model. the manifold most definitely is and the casting stamp on the head says later model, but if the block reads...
Forum: Honda CRX / EF Civic (1988 - 1991)
10-15-2017, 03:08 PM
Replies: 8
Views: 811
Posted By v4lu3s

Re: Low compression please help

cheap and easy do nothing.
correct is rebuild it and replace worn or damaged parts.
Forum: Honda CRX / EF Civic (1988 - 1991)
10-15-2017, 02:30 PM
Replies: 5
Views: 2,632
Posted By v4lu3s

Re: Jdm ef6 1.5x dual carb to b series question

you can use the original fuel line as a return line.
Forum: Honda Civic (2001 - 2005)
09-23-2017, 02:24 PM
Replies: 42
Views: 2,327
Posted By v4lu3s

Re: How much can I tow?

just remember if you have an accident you will most likely be held at fault no matter what as you have exceeded the tow rating of your vehicle.
Forum: Engine Management and Tuning
09-21-2017, 03:56 AM
Replies: 13
Views: 5,276
Posted By v4lu3s

Re: problem with s300 and wideband

I run my wideband input to the stock o2 input with s300 and no narrow band. I was told the ELD input was flakey and not to use it unless i had to.
Forum: Engine Management and Tuning
08-26-2017, 04:16 PM
Replies: 3
Views: 3,573
Posted By v4lu3s

Re: HIGH IDLE AND RUNNING RICH!!!

aside from the idle does it drive well enough to get to the dyno and your tuner?
Forum: Tech / Misc
08-26-2017, 04:01 PM
Replies: 4
Views: 1,124
Posted By v4lu3s

Re: Oil filling cylinder 4, valve seal?guide?head?

middle of the piston coming from above?
Forum: Engine Management and Tuning
08-24-2017, 11:18 AM
Replies: 2
Views: 1,569
Posted By v4lu3s

Re: P28 virgin limp mode Fixxing

I have several p06 and p28 ecu's that take 3-10 minutes to prime the fuel pump and fire, and as best I can determine there is a problem in the injector circuits on the board, and basically i just...
Forum: Tech / Misc
08-20-2017, 07:06 AM
Replies: 10
Views: 13,258
Posted By v4lu3s

Re: PCV breather box removal / BWR installed

if you are wanting to keep the outside of your engine covered in a nice thin layer of oil mist those work well.
Forum: Honda CRX / EF Civic (1988 - 1991)
08-18-2017, 06:15 AM
Replies: 6
Views: 983
Posted By v4lu3s

Re: Recommended Vendor for rebuilt cylinder head?

I would use my local machine shop.
Forum: Engine Management and Tuning
08-10-2017, 02:18 AM
Replies: 3
Views: 456
Posted By v4lu3s

Re: What is a fair price for a tune up?

There is no such thing as a tune-up anymore. That was for a time when you replace the oil check your points in the distributor adjusted your carb and swapped plugsNeat $650 could be a very good deal...
Forum: Honda CRX / EF Civic (1988 - 1991)
08-10-2017, 02:13 AM
Replies: 11
Views: 1,572
Posted By v4lu3s

Re: need help running grounds

Replace it.
Forum: Honda CRX / EF Civic (1988 - 1991)
08-09-2017, 01:15 PM
Replies: 10
Views: 1,618
Posted By v4lu3s

Re: having affair with FIT ... am i wrong?

The Honda Fit has a coefficient of drag of 0.35
ef civic is .28 to 0.32 depending on the model
so no it is not more aerodynamic
Forum: Honda CRX / EF Civic (1988 - 1991)
08-09-2017, 01:01 PM
Replies: 13
Views: 5,907
Posted By v4lu3s

Re: EE8/ED9 Milano Red CRX story

That is some amazing work your attention to detail is outstanding.
Forum: Tech / Misc
07-21-2017, 12:59 PM
Replies: 15
Views: 3,527
Posted By v4lu3s

Re: -AN vs NPT, have a question

NPT is national pipe taper, it would need an adapter as AN is straight thread and afaik is measured by the pipe inner diameter, -AN is measured by tube outer diameter which is not relatable to inner...
Forum: Honda CRX / EF Civic (1988 - 1991)
07-21-2017, 12:48 PM
Replies: 3
Views: 677
Posted By v4lu3s

Re: ed3 dont Injects after b16a1 swap

are you getting fuel to the rail? also test with a light to see if the injector is pulsing
Showing results 1 to 25 of 492
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 01:41 PM.