Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: pentaq
Showing results 1 to 25 of 483
Search took 1.88 seconds.
Forum: Tech / Misc
01-27-2017, 06:01 AM
Replies: 0
Views: 1,703
Posted By pentaq

Hybrid ignition system Design: A new idea to discuss

It's pretty common in older Hondas that the ignition coil goes bad in most unexpected place and time. Especially if it's the internal one. Maybe it's too hot inside the distributor or whatever....
Forum: Honda Prelude
05-02-2016, 11:28 AM
Replies: 7
Views: 4,657
Posted By pentaq

Re: 98 prelude base transmission interchangeabilty?

You have three solutions:
1. Replace the same prelude tranny (although be prepared it will break soon).
2. Replace with any accord/4gen prelude transmission with all electronics.
3. Swap to manual.
Forum: Honda Accord (1990 - 2002)
10-27-2015, 05:38 AM
Replies: 1
Views: 1,243
Posted By pentaq

Re: V gen sedan doors the same as in wagon?

Yes, they fit.
Thanks ;)
Forum: Honda Accord (1990 - 2002)
10-25-2015, 02:40 PM
Replies: 1
Views: 1,243
Posted By pentaq

V gen sedan doors the same as in wagon?

Are they the same? They look so. I need a confirmation as I can't find wagon doors around. Only sedan's are available.
Thanks.
Forum: Honda Prelude
05-27-2015, 03:37 AM
Replies: 24
Views: 18,612
Posted By pentaq

Re: Max boost for stock h23 block

H23 crank is prone to wobble on high rev as a result of poor balancing, so crank bearings say good bye. Take a crank, a clutch, a flywheel, and a crank pulley to the shop and they will balance the...
Forum: Honda Prelude
05-22-2015, 02:28 PM
Replies: 24
Views: 18,612
Posted By pentaq

Re: Max boost for stock h23 block

For sure is. I'd balance the crank for peace of mind.
Forum: Tech / Misc
02-17-2015, 02:08 AM
Replies: 3
Views: 2,753
Posted By pentaq

Re: Power steering pump battle

Cheaper at that time. And the pump looked brand new inside except the bearing and simmering, so I gave a chance.
Forum: Tech / Misc
02-16-2015, 01:22 PM
Replies: 3
Views: 2,753
Posted By pentaq

Icon6 Power steering pump battle

hi,
the bearing in my power steering pump started to make a terrible noise. I bought the proper bearing (NOK with one side sealed). Disassembled the pump, replaced the simmering and the bearing....
Forum: Honda Prelude
02-16-2015, 01:14 PM
Replies: 25
Views: 12,321
Posted By pentaq

Re: Oil Leak of Death

The upper neck of the radiator is prone to crack. Check this out when the engine is hot.
Forum: Honda Prelude
02-16-2015, 01:10 PM
Replies: 5
Views: 417
Posted By pentaq

Re: Need help figuring out compatible parts.

Seems like OBD1 on board so P13 (stock ECU) or P28/30/72 for tuning purposes. Posting a photo of the engine bay would help a bit.
Forum: Honda Prelude
01-28-2015, 03:20 AM
Replies: 25
Views: 12,321
Posted By pentaq

Re: Oil Leak of Death

I doubt if non-pressurised oil will leak from the head gasket area like this. It's too much of oil simply. Did you clean pistons?
Forum: Honda Prelude
01-08-2015, 06:38 AM
Replies: 19
Views: 6,607
Posted By pentaq

Re: Rosko Racing Prelude H2B Kit

Sweet. Custom job or commercially available?
Forum: Honda Prelude
01-08-2015, 06:22 AM
Replies: 19
Views: 6,607
Posted By pentaq

Re: Rosko Racing Prelude H2B Kit

I'd be interested in this roller cam stuff. Could you elaborate more, please?
Forum: Honda Prelude
01-03-2015, 11:12 AM
Replies: 2
Views: 729
Posted By pentaq

Re: ID725cc injectors on h22 install?

Just stick them into the manifold with proper orings and you're good to go.
Forum: Honda Prelude
12-31-2014, 05:36 AM
Replies: 6
Views: 766
Posted By pentaq

Re: Neverending Misfire on Cyl 2. please help

Try swapping a coil and/or ignition module.
Forum: Honda Prelude
12-31-2014, 05:33 AM
Replies: 2
Views: 861
Posted By pentaq

Re: H22A4 Build up!!! NEED HELP ASAP!!!

You'll have to check if pistons don't stick out from the block too much. And there could be an issue with the piston pin offset when using OE pistons.
Forum: Honda Prelude
11-13-2014, 12:03 PM
Replies: 5
Views: 1,486
Posted By pentaq

Re: H22a NO SPARK NEED HELP!

The coil is gone. The weakest point in the whole system.
Forum: Honda Prelude
11-13-2014, 12:01 PM
Replies: 14
Views: 4,028
Posted By pentaq

Re: H22A Oil Pressure

It's ok. Never too much. Removing balance shafts will raise the pressure.
Forum: Honda Prelude
07-30-2014, 01:28 PM
Replies: 69
Views: 32,599
Posted By pentaq

Re: WANTED TO BUY ONLY :: NO TRIAL USERS, NO PICTURES - Jan- Mar 2014

WTB 3-4 hub and sychro sleeve used in a good condition needed badly.
From T2T4 T2W4 U2Q7 M2Y4 M2U4 M2F4 M2A4 M2B4 transmissions.

Important: hub should be 75mm diameter measuring on the top of the...
Forum: Want to Buy
07-30-2014, 12:44 PM
Replies: 2
Views: 398
Posted By pentaq

3-4 gear hub and synchro sleeve H22

Used in a good condition needed badly.
From T2T4 T2W4 U2Q7 M2Y4 M2U4 M2F4 M2A4 M2B4 transmissions.

Important: hub should be 75mm diameter measuring on the top of the teeth.
Payment by paypal....
Forum: Honda Prelude
06-17-2014, 03:56 AM
Replies: 3
Views: 1,192
Posted By pentaq

Re: no spark on 96 vtec prelude

I'd say replace coil anyway. It always goes bad.
Forum: Honda Prelude
06-09-2014, 04:55 AM
Replies: 5
Views: 1,223
Posted By pentaq

Re: Does anyone know where this vacuum hose goes??

It goes down to the resonator in the bumper.
Forum: Honda Prelude
06-09-2014, 04:49 AM
Replies: 10
Views: 3,125
Posted By pentaq

Re: My fabricated engine mount. Critique it

yep, you need support from the bottom. It will drop off/break the weld if you hit the hole on the road.
Forum: Honda Prelude
05-08-2014, 03:03 AM
Replies: 2
Views: 549
Posted By pentaq

Re: Question about stamps on the engine

Nothing wrong with that. H22 and H23 share the same block and upper plenum of intake manifold.
Forum: Honda Prelude
10-24-2013, 01:22 AM
Replies: 9
Views: 1,192
Posted By pentaq

Re: Stupid transmission m2b4 please help!!!

People with 600hp use stock transmissions.
Showing results 1 to 25 of 483
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 10:16 PM.