Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: BreakStuff
Showing results 1 to 25 of 497
Search took 1.71 seconds.
Forum: Tech / Misc
01-20-2003, 01:29 PM
Replies: 1
Views: 502
Posted By BreakStuff

Re: can u put a air conditioning unit from a 1989 civic dx into a 1990 honda civic with a b16a1 engi

Yes.. but I would think twice before attempting the swap..

The aluminum lines will most likely be frozen together and cannot be seperated without creating some other type of damage...
Forum: Tech / Misc
01-20-2003, 01:26 PM
Replies: 3
Views: 574
Posted By BreakStuff

Re: 2001 civic dx 5speed tranny-hard to shift into second when cold (kappi84)

normal operation..

Colder conditions will cause the tranny fluid to become as thick as molasses....
Forum: Tech / Misc
11-13-2002, 06:16 PM
Replies: 5
Views: 861
Posted By BreakStuff

Re: exhaust leaks when using clamps??? (keebler65)

Very nice pic I must say.. : )

Your clamp should actually be slightly tighter than the pic shows.. If you tighten the clamps up untill the pipe compresses, then you should not have a leak.. You...
Forum: Tech / Misc
11-13-2002, 06:08 PM
Replies: 1
Views: 602
Posted By BreakStuff

Re: Shift Boot On 92 Accord (LivinItUp)

I would remove that square clip from the boot and somehow tie it up just underneath the shifter knob.. if you remove the whole boot, then it will look like shit...

But if you must, then removing...
Forum: Tech / Misc
11-13-2002, 06:04 PM
Replies: 2
Views: 578
Posted By BreakStuff

Re: How to remove A/C from 90 Si (uncleben)

You got it bro... look at the location of the a/c compressor and remove all attached components including wire harnesses, a/c compressor, hoses, condensor, condensor fan, receiver/dryer unit....
...
Forum: Tech / Misc
11-13-2002, 05:56 PM
Replies: 3
Views: 479
Posted By BreakStuff

Re: Throw out bearing? (hatchman92)

No..

Has your hydraulic clutch been properly bled?

Do you still have a brake fluid leak somewhere in the hydraulic clutch system?..

Maybe its time to replace the clutch?...
Forum: Tech / Misc
10-22-2002, 07:52 PM
Replies: 3
How
Views: 455
Posted By BreakStuff

Re: How (sackdz)

its actually the lock cylinder that locks the steering wheel into place... if it bothers you... loosen the clamps that hold the ignition switch into place and "turn/install" it in a place where the...
Forum: Tech / Misc
10-21-2002, 06:03 PM
Replies: 7
Views: 476
Posted By BreakStuff

Re: PLEASE come check out my story and help!!!! (bruthaboost)

https://honda-tech.com/zerothread?id=232985
Forum: Tech / Misc
10-21-2002, 05:56 PM
Replies: 2
Views: 751
Posted By BreakStuff

Re: Locate the main relay on a 90 crx? (gcajnr21)

Its tucked up underneath the drivers side dash... black box about 4"x 2", I thinks it mounted upside down in your car and has a big brown connector... just stick your head underneath the drivers side...
Forum: Tech / Misc
10-21-2002, 05:45 PM
Replies: 22
Views: 8,414
Posted By BreakStuff

Re: Rattle coming from distributor... (TREVER)

Any Honda/Acura dealer... Thats the cost of the distributor body and doesnt include a coil, ignitor, cap or rotor...
Forum: Tech / Misc
10-19-2002, 06:43 PM
Replies: 9
Views: 485
Posted By BreakStuff

Re: carb motors................no, really (86CRXSi)

It might be found using the search function... The same concept was brought up here in a similiar post a couple months back.. pretty cool idea!...
Forum: Tech / Misc
10-19-2002, 06:40 PM
Replies: 22
Views: 8,414
Posted By BreakStuff

Re: Rattle coming from distributor... (newgsrdriver)

easy enough diagnosis...

Remove the distributor and see if you can "wobble" the shaft...

If so...time for a new distributor assembly... (approx $75 new)....
Forum: Tech / Misc
10-12-2002, 11:53 PM
Replies: 13
Views: 9,050
Posted By BreakStuff

Re: Should I ever grease the lugnuts? (ls_vtec_b18a1)

can someone explain the "dry" theory to me?...

I'm not saying it's right or wrong, I would just like to understand why this is the case..
Forum: Tech / Misc
10-12-2002, 10:45 PM
Replies: 13
Views: 9,050
Posted By BreakStuff

Re: Should I ever grease the lugnuts? (DX-R)

I grease lugnuts....

Its the lugs that haven't been removed in a long period of time that create all the problems.. this is especially true with alloy rims due to that super-bonding affect of...
Forum: Tech / Misc
10-12-2002, 06:59 PM
Replies: 4
Views: 356
Posted By BreakStuff

Re: snow tires (oioioi)

two words...

Nokia Hakkapelita..

http://images.zeroforum.com/smile/emsmile.gif
Forum: Tech / Misc
10-12-2002, 06:53 PM
Replies: 12
Views: 634
Posted By BreakStuff

Re: Throwout bearing problem?? (3rdGteg)

ok... stop forcing it in..

Was the clutch replaced?

The pedal should feel nice and stiff requiring a good amount of pressure depressing and releasing...

A tip for bleeding the clutch system...
Forum: Tech / Misc
10-12-2002, 06:43 PM
Replies: 9
Views: 415
Posted By BreakStuff

Re: Yet another O2 primary sensor problem (Dr. RAB01GSR)

4 wires = heated 02 sensor... don't experiment and find schematics...
Forum: Tech / Misc
10-12-2002, 06:41 PM
Replies: 4
Views: 581
Posted By BreakStuff

Re: clutch chatter (DX-R)

Once a chatter, always a chatter... its time to face the facts and get used to the chatter cause it always going to be there.. My ex-girlfriend was also a "chatterer" and wouldn't shut the !@#$ up...
Forum: Tech / Misc
10-12-2002, 06:28 PM
Replies: 6
Views: 481
Posted By BreakStuff

Re: engine ok? (12345)

If the T-belt snapped it may not easy to visually see any damage if the valve contacted the piston..

If the cams had to be removed as part of the head removal, then all valves should be "shut"..
...
Forum: Tech / Misc
10-12-2002, 06:13 PM
Replies: 2
Views: 519
Posted By BreakStuff

Re: imobilizer removal?? (miahmouse)

If I understand correctly... If you are going to be re-installing the original ECU, then the immobi system should function normally and not prevent you from starting the car..
Forum: Tech / Misc
10-12-2002, 06:06 PM
Replies: 9
Views: 415
Posted By BreakStuff

Re: Yet another O2 primary sensor problem (Dr. RAB01GSR)

I think it would be safe to experiment here and just connect the wires together... If you get the wires crossed it will affect air/fuel mix and make the car idle like crap and eventually throw a...
Forum: Tech / Misc
10-12-2002, 05:56 PM
Replies: 5
Views: 594
Posted By BreakStuff

Re: 91 civic EGR (Pepsi90919)

Mines a 91 LX 5spd with the same motor and not equipped with an EGR system..
Forum: Tech / Misc
10-12-2002, 05:48 PM
Replies: 9
Views: 415
Posted By BreakStuff

Re: Yet another O2 primary sensor problem (Dr. RAB01GSR)

Usually it just takes a little push on the wire terminal to "lock" it within the connector..

if the terminals were accidentally pulled out, the the lock tabs in the connector may have broken off...
Forum: Tech / Misc
10-12-2002, 05:36 PM
Replies: 9
Views: 1,114
Posted By BreakStuff

Re: HELP - green stuff dripping from water pump! (tinkerbell)

This info comes directly from AHM..

"A little coolant leakage from the water pump weep hole doesn't necessarily mean the pump seal is shot. The weep hole is just doing its job of keeping the...
Showing results 1 to 25 of 497
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 04:23 AM.