Honda-Tech - Honda Forum Discussion

Notices
 
Page 1 of 17
1
2
3
11
Last »
Search: Posts Made By: BoM
Showing results 1 to 25 of 409
Search took 1.29 seconds.
Forum: All Motor / Naturally Aspirated
08-04-2011, 10:12 AM
Replies: 4
Views: 1,203
Posted By BoM

Re: Advice needed: Slick size??

You will want the 22".
22x8x13 have been the normal for the past decade. Since you already have civic brakes your set!
The 20" will be overpowered at your power.
Forum: Forced Induction
05-17-2011, 07:32 AM
Replies: 18
Views: 4,663
Posted By BoM

Re: B18C1 Turbo Opinions - Dynograph inside

Precision SC61 is the turbo I think you want. An easy 60whp increase from what you have running now.
Forum: Forced Induction
05-17-2011, 07:31 AM
Replies: 18
Views: 4,663
Posted By BoM

Re: B18C1 Turbo Opinions - Dynograph inside

Time to upgrade to a precision turbo man.
I hate those dyno sheets too. I like to see the torque cross HP @5252 rpm on them.
Forum: Forced Induction
05-17-2011, 07:23 AM
Replies: 9
Views: 1,017
Posted By BoM

Re: dont know which manifold to go with .. log good for 350whp?

You can make a lot of horsepower with the simple log manifold.
It's all in the turbo choice, fuel and tuning. He made 600 with E85.
The log has a little more lag. Again with his E85 the lag is...
Forum: Drag Racing
05-17-2011, 07:19 AM
Replies: 12
Views: 3,678
Posted By BoM

Re: First time on slicks *B16 content

B16's are hard to launch...You need more torque.
Forum: Forced Induction
02-18-2010, 10:28 AM
Replies: 44
Views: 39,534
Posted By BoM

Re: long gear vs short gear trans for boost

Just know that if you have a LS tranny in your already turbo B18 car. Then, swap in a GSR tranny into it you usually go faster, but introduce a lot more wheel spin.

Just think about it in the...
Forum: Honda Accord & Crosstour (2003 - 2012)
11-17-2009, 10:32 AM
Replies: 12
Views: 1,900
Posted By BoM

Re: Starting Problem with Clutch [VIDEO]

If its an intermittent problem with starting. Then, its usually is a bad starter. Usually the starters clutch can't push the the gear completely flush to the flywheel so I kind of grinds with it....
Forum: Honda Civic / Del Sol (1992 - 2000)
11-16-2009, 06:25 AM
Replies: 5
Views: 1,976
Posted By BoM

Re: Does Open Exhaust help performance?

Yes, usually always gain topend power, but most of the time you lose low end and mid range torque. You need it to be tuned and set up for it to be effective. Something with a e-cutout of something...
Forum: Honda Civic (2006 - 2015)
07-21-2007, 10:01 AM
Replies: 84
Views: 8,729
Posted By BoM

Re: (BoM)

WTB: SEDAN SI REAR AXLE MUFFLER
I just need the rear muffler for my EX sedan.
I like how the SI muffler sounds and looks. I dont' want my EX to be any louder than that.
Forum: Honda Civic (2006 - 2015)
07-21-2007, 09:55 AM
Replies: 84
Views: 8,729
Posted By BoM

Re: (cutler2start)

SOUTH JERSEY

2007 EX SEDAN

WTT: MY wingless NHBP trunk for a OEM NHBP trunk with spoiler (not the lip one)
Plus Cash...
Forum: Honda Civic (2006 - 2015)
07-21-2007, 09:19 AM
Replies: 2
Views: 447
Posted By BoM

R there Online shops with only 8th gen parts?

i'm having trouble finding a good selection of parts..

thanks
Forum: Forced Induction
05-19-2007, 07:25 AM
Replies: 8
Views: 9,773
Posted By BoM

Re: Does the HKS SSQV flange work with Tial Bov? (pheurton-skeurto)

thanks, i didn't know the tial was only vband.
chad coffer PM me.
Forum: Forced Induction
05-17-2007, 11:34 PM
Replies: 8
Views: 9,773
Posted By BoM

Does the HKS SSQV flange work with Tial Bov?

tial uses 50mm flange right??
i think the HKS one is the same size.
Can they share the same flange?
Forum: For Sale
05-17-2007, 06:28 AM
Replies: 0
Views: 400
Posted By BoM

FS/NJ: Racing Seats, EG 5" tach and gauge pod, 3" downpipe

http://forums.evolutionm.net/s...39574 (http://forums.evolutionm.net/showthread.php?p=4339574&posted=1#post4339574) Pictures here post #8

$200 or BO
2 Universal Black Racing Seats with sliders....
Forum: For Sale
05-17-2007, 05:57 AM
Replies: 0
Views: 321
Posted By BoM

FS:NJ: 95' GSR Complete WIRING Harness

$150
has everything from MY engine.
from the battery cables to the injector clips with metal clips still on em.
Every sensor.

PM your email for Pictures.
Forum: Want to Buy
02-06-2007, 07:41 PM
Replies: 12
Views: 435
Posted By BoM

Re: WTB/WFF: 92-95 DENJI projector (Mr HYDE)

I have them but my projector section is blue. I'll try to get a picture. I think its just the bulb that makes it blue. If you have an email i can send you it.

I'll sell it pretty cheap. Shipping...
Forum: Want to Buy
02-06-2007, 07:35 PM
Replies: 2
Views: 196
Posted By BoM

Re: WTB: Virgin USDM OBD1 P72 (slow-as-heck)

i have one from my totalled 95' Integra GSR
Still works great, cause my buddy tries it on his h22 powered civic sometimes.

Asking price $100 shipped
paypal verfied and everything...
Forum: For Sale
11-08-2006, 05:55 PM
Replies: 0
Views: 240
Posted By BoM

FS: DSLR's Canon Rebel XT & XTI and SONY A100

i have these BRAND NEW DSLR's for a good deal.

PM FOR PRICES!
Will Price Match any good Ad.

Canon Rebel XT kit black with 18-55 lens
http://www.dpreview.com/review...d.asp...
Forum: Classifieds: Forced Induction
10-31-2006, 08:06 PM
Replies: 0
Views: 265
Posted By BoM

WTB: HKS EVC EZII new or used.

need a electronic boost controller
huyt@camden.rutgers.edu

paypal verified.
Forum: Classifieds: Forced Induction
09-07-2006, 06:12 AM
Replies: 1
Views: 320
Posted By BoM

Re: FS: AVCR boost controller (BoM)

bump
Forum: For Sale
09-06-2006, 05:59 AM
Replies: 0
Views: 233
Posted By BoM

FS: Cheap NEW Digital Cameras

I get some pretty good deals working in a camera store. So im gonna test some. All new, shipped right away.

Canon SD630 - slim camera. It has 6megapixel, 3x optical, 3inch LCD, HI ISO, DIGIC II...
Forum: Classifieds: Forced Induction
09-06-2006, 05:55 AM
Replies: 1
Views: 320
Posted By BoM

FS: AVCR boost controller

Everything but the box. No stratches on the face or anything. No cut wires or anything. A really good condition boost controller with all the goodies to tune your boost for two maps. Doubles as a...
Forum: Classifieds: Forced Induction
04-25-2006, 07:26 AM
Replies: 6
Views: 624
Posted By BoM

FS: Precision turbo t3/t4 .63 a/r with -3an feed and -10an return and bung.

$550 shipped NEW Precision SC60 turbo rated to 580hp. Including SS oil feed and return lines also a weld in and/or skrew in bung for the return.
http://www.we-todd-did-racing....D.jpg...
Forum: For Sale
12-01-2005, 04:28 PM
Replies: 4
Views: 302
Posted By BoM

Re: (BoM)

bump for a D200
Showing results 1 to 25 of 409
 
Page 1 of 17
1
2
3
11
Last »


 
Forum Jump


All times are GMT -8. The time now is 09:26 PM.