I changed the timing belt on my Odyssey. The problem began when I went to start the engine after install. At idle the engine revs between 1.5 and 2.5 rpms. Checked timing marks and all reference marks were aligned. Also the check engine light came on with a P0336 code. I have removed the alternator and the battery and they both bench tested fine. Took the van on a little test run down the road and it actually stabilized at 1000 rpm and then when I drove about a 1/4 of a mile, the engine started surging again. Checked all the connectors that I removed and everything appears to be o.k. I haven't taken everything back apart to check the CKP sensor yet, was hoping somebody would have a better idea of what to check before I tore everything apart again. Also I checked the p.s. sensor wiring everything ok there to. I am at a lose for what to do next. Any ideas or helpful hints?
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.