Honda-Tech - Honda Forum Discussion

Honda-Tech - Honda Forum Discussion (https://honda-tech.com/forums/)
-   Honda CRX / EF Civic (1988 - 1991) (https://honda-tech.com/forums/honda-crx-ef-civic-1988-1991-3/)
-   -   What if i dont change my O2 sensor??? (https://honda-tech.com/forums/honda-crx-ef-civic-1988-1991-3/what-if-i-dont-change-my-o2-sensor-454092/)

crxtreme27 03-25-2003 02:56 PM

What if i dont change my O2 sensor???
 
For the past two months (about 2k miles)i have been driving around with my check engine light on, which says code 1 (O2 sensor)... will anything bad happen to my engine?? should i not drive the car until i get it fixed??
thanks

RCautoworks 03-25-2003 03:12 PM

Re: What if i dont change my O2 sensor??? (crxtreme27)
 
Your car will be in limp mode, which if you drive in limp mode for to long I heards it not good. Why not fix it ?


[Modified by 90blackcrx, 6:12 PM 3/25/2003]

Charlie Moua 03-25-2003 04:05 PM

Re: What if i dont change my O2 sensor??? (90blackcrx)
 
well honestly my car is in storage and has been driven a total of about 5k with a bad 02 sensor..... no problems.

RCautoworks 03-26-2003 06:21 AM

Re: What if i dont change my O2 sensor??? (Charlie Moua)
 
Well I only heard that when you finally get the check engine light fixed, then the engine don't run like its ment to be cause its been running so rich for so long.


[Modified by 90blackcrx, 11:33 AM 3/26/2003]

Blaze45 03-26-2003 06:42 AM

Re: What if i dont change my O2 sensor??? (90blackcrx)
 
my 02 does the same thing. I just shut the car off then turn it back on, no check engine and no limp mode.

Blaze

ScottEK 03-26-2003 07:04 AM

Re: What if i dont change my O2 sensor??? (Blaze45)
 
If you dont have an o2 sensor working properly then you are never going to have the correct A/F ratio. I believe if there is no signal at all the ECU puts it into limp mode and it runs very rich to prevent a lean condtion. This means you'll get horrible fuel mileage and you'll have to clean up your spark plugs when you do get around to replacing it. Last time I replaced one I used a Bosch universal and just soldered on the plug from my last one, I think the total was $42.00 at autozone.


All times are GMT -8. The time now is 10:27 AM.


© 2024 MH Sub I, LLC dba Internet Brands