speedometer dont work
I got a eg hatch with a Gsr swap. I just got a new speed sensor and my speedometer still doesn't work. I tried 2 sensors and 3 clusters...anyone help
|
Re: speedometer dont work
|
Re: speedometer dont work
Should have a check engine light on, get the code and see what it says.
|
Re: speedometer dont work
|
Re: speedometer dont work
Illuminated CEL means no VTEC. It not engaging has nothing to do with the VSS.
|
Re: speedometer dont work
mostlikely the plug that plugs into the VSS. they corrode over time. I just replaced mine and my speedo is back in action.
|
Re: speedometer dont work
ok. i tried wiring the vss to the ecu and now the middle wire (yellow/blue) to power and its not sending any fuel? for it to send fuel, i need to wire it to the battery and then unplug it everytime so my battery doesn't drain out. i'll try a new plug and see how that goes too.
|
Re: speedometer dont work
go to a junk yard and cut a few connectors with wires to replace the connector end on the harness along with a few inches of wire. I found mine was corroded badly and that fixed it. Theres no need to run a new wire from the vss to the ecu if you just have a bad end.
|
Re: speedometer dont work
Got new connectors and it still don't work. Idk any more
|
Re: speedometer dont work
cluster thats about the only thing i can see that it can be
|
Re: speedometer dont work
As code 17 is not thrown, check whether the wire running between the VSS plug and cluster/speedometer is broken.
|
Re: speedometer dont work
Does anyone know to speedometer pinouts on the cluster? I want to check if there is any voltage going through..
|
Re: speedometer dont work
The VSS speed signal wire runs to B2 (Yel/Blu wire) in the cluster. Check for continuity (not voltage) from B2 in the cluster connector to the Yel/Wht wire terminal in the VSS connector.
http://i639.photobucket.com/albums/u...cture_6808.jpg |
Re: speedometer dont work
Ok...I checked b2 and there is power going through. Question is, wherecan I find the other end?
|
Re: speedometer dont work
Still having problems, it won't work...Idk any more...plz help
|
Re: speedometer dont work
Your wiring harness may be bad. No speed sensor means no vtec!
|
Re: speedometer dont work
take it apart piece by piece play with the spring clean it all as much as you can put it back together check voltage at the clip i got around 3v. very finiky sensor. I couldnt get a continuity reading but my leads were kinda broken ...
|
All times are GMT -8. The time now is 04:25 AM. |
© 2024 MH Sub I, LLC dba Internet Brands