91 Accord Transmission Problem
I start the car and put it in reverse and its fine, but when I put it in drive and start to move it starts to run fine for a couple inches then starts slipping and the "s" light blinks until i turn the car off again. I was hoping it might just be the solenoid or the trans computer but something tells me the trans is done. Any input is appreciated
|
Re: 91 Accord Transmission Problem
Originally Posted by invader_zim
(Post 47110876)
I start the car and put it in reverse and its fine, but when I put it in drive and start to move it starts to run fine for a couple inches then starts slipping and the "s" light blinks until i turn the car off again. I was hoping it might just be the solenoid or the trans computer but something tells me the trans is done. Any input is appreciated
|
Re: 91 Accord Transmission Problem
Thank you, I checked the codes and got code 1, 2 & 8. Im guessing that my shift solenoid needs cleaning? Going to go clean it and report back
|
Re: 91 Accord Transmission Problem
Keep in mind, if you looked over that link, that some 90-91 TCUs had bad capacitors/resistors. Before you pull solenoids out, carefully remove the TCU and inspect its capacitors and resistors.
|
Re: 91 Accord Transmission Problem
took out the tcu and inspected it, everything looks fine as far as that goes. going to be taking off the shift solenoid and cleaning it in a few minutes
|
Re: 91 Accord Transmission Problem
Both solenoid assemblies have been cleaned and the only code now is code 8
|
Re: 91 Accord Transmission Problem
Originally Posted by invader_zim
(Post 47114765)
Both solenoid assemblies have been cleaned and the only code now is code 8
|
Re: 91 Accord Transmission Problem
Problem solved, it ended up being the sift solenoid. Replaced it andif shifts smoother than it did before. Thank you for your time and help!
|
All times are GMT -8. The time now is 02:26 AM. |
© 2024 MH Sub I, LLC dba Internet Brands