resurface head
okay guys I have a resurfaced head and block but I have taken the head off about 4 times (and torqued down) and put about 30 miles at the most on the motor. I'm about to put a new HG because the one in there is leaking. Do you guys think I will need to resurface the head or should I be good?
|
Re: resurface head
Fail
|
Re: resurface head
No need to resurface the head.
|
Re: resurface head
Originally Posted by nelson9994
(Post 46263734)
okay guys I have a resurfaced head and block but I have taken the head off about 4 times (and torqued down) and put about 30 miles at the most on the motor. I'm about to put a new HG because the one in there is leaking. Do you guys think I will need to resurface the head or should I be good?
|
Re: resurface head
I didnt blow 4 HG.... heres the story
i did a 1 layer first time then cr was goonna be at like 12:8 so i took it out and did the other 2 layers then i said f it took it off again and put a new one in i put it on upside down so it was leaking alot then i took a used one i had and put it in this one looked ok but it had hella miles and is leaking too oil (alot) so i ordered a brand new one this time |
Re: resurface head
Originally Posted by nelson9994
(Post 46266779)
I didnt blow 4 HG.... heres the story
i did a 1 layer first time then cr was goonna be at like 12:8 so i took it out and did the other 2 layers then i said f it took it off again and put a new one in i put it on upside down so it was leaking alot then i took a used one i had and put it in this one looked ok but it had hella miles and is leaking too oil (alot) so i ordered a brand new one this time |
Re: resurface head
Aka NOOB
|
Re: resurface head
Practice makes perfect! :)
If the head and block have been milled, make sure your dowel pins aren't keeping those corners of the head from seating all the way (can cause oil leaks)... Check them to see if they need milled down too... |
Re: resurface head
im going to mill them down a bit anyways. my question is do you guys think the head needs to be resurfaced or should i be good
|
Re: resurface head
put a precision straightedge on it and see what feeler gauges can go under it if any. I think factory manual says .002" is max warpage. but if there is any warpage, I just get it decked anyways.
|
Re: resurface head
I dont have a straightedge or the money to buy it right now... I will eventually check it when I get the money...
BTW... how do heads lose their straightness??? is it once is torqued down, or if it over heats or the miles or what.... because even though I am not sure... after 40 miles it doesn't sound like alot of miles for it to need a resurfacing or does it because it has been torqued 4 times or what? |
All times are GMT -8. The time now is 07:06 PM. |
© 2024 MH Sub I, LLC dba Internet Brands