D16 head on D15 Block
 

The title is pretty much the question at hand

will a d16 vrec head fit on a d15 block with no modification or do i need to run the vtec oil lines like on the B series dohc motors?

any and all info about this will help greatly.

Thanks for helping out.

Re: D16 head on D15 Block
 

it fits. its called a minime. no oil lines. take out the oiler in the block when you put the head on and you need to use the d16 timing belt, dizzy and all its atachments. you should get a z6 or y8 intake mani for it. iv never heard of vrec....

Re: D16 head on D15 Block
 

vrec?

and whats the oiler (oil dowels?) main oil feed in the oil pan?

Please be more informative

thanks for the other info though. Big help

Re: D16 head on D15 Block
 

new information ---- The guy who i'm buying the motor from missread the code

its a d16 non vtec block
and i have the d16 vtec head

Bolt right up or need modification?

Re: D16 head on D15 Block
 

i have a d16z6 vtec for sale.100k.no oil leaks.+new altenator,water pump 1k,trans,
axels 10k,ecm fuel rod,ect.....realized i want a gsr?????u r kinda far???anybody

Re: D16 head on D15 Block
 

$700

Re: D16 head on D15 Block
 

i take it its a D16Y7 block and a Y8 head?

Re: D16 head on D15 Block
 

700 can get you a gsr block or ls motor and tranny in some places.
but on the block in the dowel pin areas there is a thingy pressed in a hole. take it out, it gets oil to the top now that you need more oil up there, no need to switch timing belts then. just put it on and wire vtec

Re: D16 head on D15 Block
 

PLEASE STAY ON TOPIC THIS IS NOT A FOR SALE THREAD IF YOU MISS POST AGAIN YOU WILL BE REPORTED

Re: D16 head on D15 Block
 

I would just buy a d16z6, d15b, or d16y8 there easy to find very cheap and it will be more reliable and much easier to do

Re: D16 head on D15 Block
 

just get the D16 Block and the head. There is no such thing as a non-vtec block. No Blocks have vtec. vtec is all in the head. So yes it will completely bolt up with no problems, and make a D16 VTEC motor. Now depending on the D16 Block it will yeild different amounts of power. And have a different compression ratio. What is the code on the D16 Block?

Re: D16 head on D15 Block
 

would a minime swap pass smog in cali ?

Re: D16 head on D15 Block
 

Re: D16 head on D15 Block
 

Re: D16 head on D15 Block
 

vtec will work if iacv is jacked up.
very easy to wire vtec. some cars came wired for vtec to the shock tower. if you don't have it run it to the ecu. go to the junk yard and get ecu pins. make your self a vtec harness.
there are 2 types of IACV. I believe the GSR had a dif bolt pattern. idle up and down is iacv of air bubbles in coolant