removing vtec oil passage plug in head
 

I've got a b16 head that was previously setup for LS-vtec. It has a fitting in the oil port, and then some of that quik-steel shit over the fitting. I'm kind of stuck trying to figure out how to remove the shit. Should I just drill it? and if so do I have any room for error? any other ideas?

Re: removing vtec oil passage plug in head (bambbrose)
 

if it was done right it should screw right out, maybe with a lilttle force since that quicksteel shit is on there, if it was a ls/vtec kit fitting then i believe it's a 13 or 14 mm to take it out, and if it wasn't then i'm sorry but i can't help there without a pic, and i wouldn't try doing anything to it till u know for a fact if u have any room for error or not... hope this helps.....

I'll try to get a pic up tonight after work

Re: removing vtec oil passage plug in head (bambbrose)
 

small drill bit, then use an easy out