Integra JDM front swap - Need bent radiator support opinions
#1
B*a*n*n*e*d
Thread Starter
Join Date: Jan 2016
Location: Arlington TX
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Integra JDM front swap - Need bent radiator support opinions
Hi all,
I'm prepping my car before my JDM front end comes in. Purchased this car recently and after taking off the bumper, I noticed the lower radiator support is bent in towards the engine bay. It's not major but I'm concerned with fitment issues later on.
I originally planned to do the "T" bar swap method for the JDM rad support but seeing this, makes me think twice. Should I just swap out the entire USDM support with JDM support or continue on with the "T" method?
Thanks for any input :thumb:
I'm prepping my car before my JDM front end comes in. Purchased this car recently and after taking off the bumper, I noticed the lower radiator support is bent in towards the engine bay. It's not major but I'm concerned with fitment issues later on.
I originally planned to do the "T" bar swap method for the JDM rad support but seeing this, makes me think twice. Should I just swap out the entire USDM support with JDM support or continue on with the "T" method?
Thanks for any input :thumb:
Thread
Thread Starter
Forum
Replies
Last Post
98GSRDC2
Acura Integra
4
03-06-2008 06:56 AM