bonsnick

Hello

Well I bought a 1995 eg hatch a while back with a jdm h22a engine and tranny swap already done and I like it and all but I want to swap a k20 or k24 in now that I have a good amount of money saved up and a few buddies to help with it but with the h22a swap you have to cut off the passanger tranny mount on the car and cut a hole in the trsnny tunnel so the prelude box will fit. And I was wondering what I could do now is it possible to buy new floorboards their and possible to but a new tranny mount section so weld in or am I stuck with a h22 in the car.

Thanks

cetcivic

K-swap in eg/dc require you cut off the passenger side mount.

bonsnick

Oh so it's the same as the h22a swap.

I looked at a few pictures of k20 swapped eg hatchs abd it looked like they all had the passenger side tranny mount. So since mine us cut off now then I can still swap a k20 in it. All the research I have done it says you don't need to cut off the mounts are you sure. And what about the floorboard were you have to cut a square hole can I replace that

Raihan

Bit out of date but did you manage to do your K20 swap /