K SWAP ENGINE HARNESS ???
#1
K SWAP ENGINE HARNESS ???
I need help got my car running and it runs strong but idle sometimes And I was stuck on the engine harness I have 5 wires that I have to tapped to the oem ecu plugs I got three tapped but the 2 is were I'm stuck . I not sure what engine harness I have I probably have rcrew .
My setup is a 1995 civic ex
K24a2 with kpro
My setup is a 1995 civic ex
K24a2 with kpro
#5
Re: K SWAP ENGINE HARNESS ???
The 5 wire are from the engine harness I'm using with a k24 engine . There's five the have to be tapped to my oem ecu plugs . 2 of the ones are red and white with black . I don't know what they for I haven't run down their not label like rywire one ... rkrew racing engine harness are know to have these 5 wires
#6
Re: K SWAP ENGINE HARNESS ???
I just don't want to tapped them into anyone I want to make sure we're they go and what they for the pictures show 5 and the botto one shows were they tapped them in . I got the ones the match green and yellow
Trending Topics
#8
Honda-Tech Member
Join Date: Jun 2007
Location: N.Y.
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
Re: K SWAP ENGINE HARNESS ???
This is confusing. Are these wires from the engine harness it self or a conversion harness? To me looks to be a conversion harness.
If from a conversion harness the 5 wires should be fuel pump,check engine light,eld and the two others wires I'm not sure of right now.
The colors really don't tell me much as every harness uses different colors. I need to know where exactly the 5 wires are going to tell you what there for and where you need to tap them to. 3 of the wires should go to the ecu plug and the other 2 might go to the ecu plug as well but not sure.
If from a conversion harness the 5 wires should be fuel pump,check engine light,eld and the two others wires I'm not sure of right now.
The colors really don't tell me much as every harness uses different colors. I need to know where exactly the 5 wires are going to tell you what there for and where you need to tap them to. 3 of the wires should go to the ecu plug and the other 2 might go to the ecu plug as well but not sure.
#12
Honda-Tech Member
Join Date: Sep 2014
Location: England , U.K
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Re: K SWAP ENGINE HARNESS ???
In order to see exactly which wire you need help with - could you upload pictures from the plug the wires are coming out. Try and insure we can clearly see from which plug / pin the wires are located.
Which ecu are you running i.e K100 / Kpro or stock?
Which ecu are you running i.e K100 / Kpro or stock?
#13
Honda-Tech Member
Join Date: Sep 2014
Location: England , U.K
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Re: K SWAP ENGINE HARNESS ???
#16
#18
Re: K SWAP ENGINE HARNESS ???
Got the other 2wires tapped there for 1 brake switch 2 signal switch. Not going run 02 sensor it's getting tune thanks for the help and my bugging issues was a dirty fuel filter.
Thread
Thread Starter
Forum
Replies
Last Post
BlueShadow
Forced Induction
11
12-14-2005 05:42 PM