97 civic kswap will not start please help!!!
#1
Honda-Tech Member
Thread Starter
Join Date: Oct 2010
Location: lake anna, Va
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
97 civic kswap will not start please help!!!
i just finished my kswap into a 1997 civic ex. here is the info on the swap
2004 accord block
2004 rsx type s head
2004 rsx type s trans
2004 rsx type s wire harness
hasport ekk2 mount kit
hasport conversion harness
kpro
when i turn the ignition on the main relay clicks and the check engine light comes on for a few seconds and turns off. the car will crank over just fine. the problem is there is no fuel pressure. the fuel pump is good. the problem is the computer is not grounding the pin on the main relay that triggers the fuel pump to run. i am stumped on this one. i think maybe i have not installed the hasport conversion harness correctly, but i don't know.
any thoughts?
2004 accord block
2004 rsx type s head
2004 rsx type s trans
2004 rsx type s wire harness
hasport ekk2 mount kit
hasport conversion harness
kpro
when i turn the ignition on the main relay clicks and the check engine light comes on for a few seconds and turns off. the car will crank over just fine. the problem is there is no fuel pressure. the fuel pump is good. the problem is the computer is not grounding the pin on the main relay that triggers the fuel pump to run. i am stumped on this one. i think maybe i have not installed the hasport conversion harness correctly, but i don't know.
any thoughts?
#3
Re: 97 civic kswap will not start please help!!!
In kpro have you made sure to turn off the immobilizer? I know that can be a duh question but I just wanna make sure you knew to do it. I mean I was so excited to finish my swap that I forgot to wire my immobilizer delete and spent probably two hours problem solving and even resoldered the main relay.
#4
Honda-Tech Member
Thread Starter
Join Date: Oct 2010
Location: lake anna, Va
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
Re: 97 civic kswap will not start please help!!!
In kpro have you made sure to turn off the immobilizer? I know that can be a duh question but I just wanna make sure you knew to do it. I mean I was so excited to finish my swap that I forgot to wire my immobilizer delete and spent probably two hours problem solving and even resoldered the main relay.
i had a long conversation with brian at hasport last night. he was very helpful!!! unfortunately it looks like i have a bad computer. everything is wired correctly and should be working, however the computer will not turn on the ground that activates the fuel pump. long story short i now have a direction to go moving forward with the project. thanks very much to hasport for their excellent customer service!!!
Thread
Thread Starter
Forum
Replies
Last Post