RWD shift linkage setup for a b series or h series swap
07-19-2006, 09:19 PM
#1
Thread Starter
Join Date: Oct 2003
Location: orange county, ca, usa
Posts: 354
Likes: 0
Received 0 Likes
on
0 Posts
RWD shift linkage setup for a b series or h series swap
trying to figure out how shift linkage was fabricated when the engine is in the rear?
the shaft from the trans is pointing torwards the rear of the car so how is it redirected towards the front.
i already have my engine(b20vtec 230hp), trans(b16 cable with a spool) mounted in my two seater sandrail with custom long travel rear trailing arms
I just need some ideas on how people ran the shift linkage towards the front of the car
the shaft from the trans is pointing torwards the rear of the car so how is it redirected towards the front.
i already have my engine(b20vtec 230hp), trans(b16 cable with a spool) mounted in my two seater sandrail with custom long travel rear trailing arms
I just need some ideas on how people ran the shift linkage towards the front of the car
07-19-2006, 10:30 PM
#2
Junior Member
Join Date: Jun 2006
Location: Perris, CA, Riverside
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Re: RWD shift linkage setup for a b series or h series swap (quick1racer)
look at the pst about RWD integra. from what I understand he used the NSX linkage.
07-20-2006, 08:38 AM
#4
Re: RWD shift linkage setup for a b series or h series swap (bardabe)
It wouldn't work with a B-series transmission. My guess is that any RWD B-series used automatic transmission that are connected to the shifter with cables. Also, Since the H-series uses cable linkage, you can mount the shifter anywhere you want. if the cables are long enough...
07-20-2006, 04:40 PM
#5
Banned
Join Date: Mar 2004
Location: Burgaw, NC, USA
Posts: 846
Likes: 0
Received 0 Likes
on
0 Posts
Re: RWD shift linkage setup for a b series or h series swap (94eg!)
If you flip the stock shifter so the rods are pointing towards the rear, extend the rods as necessary, attach the stationary support rod to the front of the engine, and the shift rod to the transmission rod, the motion is the same. You may have to bend the rods slightly for clearance. Make the attachment between the shifter rod and trans shift rod as short as possible, watching for clearence during rotation (side-to-side motion of the shifter).
07-20-2006, 07:20 PM
#6
Thread Starter
Join Date: Oct 2003
Location: orange county, ca, usa
Posts: 354
Likes: 0
Received 0 Likes
on
0 Posts
Re: RWD shift linkage setup for a b series or h series swap (RaceCity_USA)
good idea i will try it
i doubt that all rwd conversions use automatic trans (thats only a guess though)
i will look in to h series trans
thanks to those with useful information
i doubt that all rwd conversions use automatic trans (thats only a guess though)
i will look in to h series trans
thanks to those with useful information
Thread
Thread Starter
Forum
Replies
Last Post
extrmeboost
Welding / Fabrication
11
08-25-2007 01:12 PM
CRX MASE
Honda CRX / EF Civic (1988 - 1991)
1
09-06-2006 07:52 PM
