B20Vtec Sleeve Question
#1
Honda-Tech Member
Thread Starter
Join Date: Nov 2012
Location: Killeen, Texas
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
B20Vtec Sleeve Question
I'm in the process of starting a B20 build. Here is what I'm planning on running. It's going to be RS Machine 84.5 high compression pistons. Shot peened stock rods. ACL Bearings. ARP rod bolts. Golden Eagle block guard. GSR head. How safe will the stock sleeves be on a setup like this? When I search some say to sleeve some say it's ok not to. I want a strong and reliable engine but want to try and keep the cost down as much as possible. Thanks.
#2
Re: B20Vtec Sleeve Question
I'm in the process of starting a B20 build. Here is what I'm planning on running. It's going to be RS Machine 84.5 high compression pistons. Shot peened stock rods. ACL Bearings. ARP rod bolts. Golden Eagle block guard. GSR head. How safe will the stock sleeves be on a setup like this? When I search some say to sleeve some say it's ok not to. I want a strong and reliable engine but want to try and keep the cost down as much as possible. Thanks.
#4
Honda-Tech Member
Thread Starter
Join Date: Nov 2012
Location: Killeen, Texas
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Re: B20Vtec Sleeve Question
Ok thanks. I plan on running a chipped ECU and having it professionally tuned. As far as preventing knocking would it be better to tap the block and add a knock sensor?
Thread
Thread Starter
Forum
Replies
Last Post