When I put my ring gear on my Quaife I just took an old cut timing belt and nailed it to the leg of my shop table (4x4). Then I wrapped it around the gear about 1.5 -2 times so that when torquing the bolts the belt got tighter. It is ghetto but worked well.
Tired of the same ol' BS? Some place better: LINK
Rotrex BA8 project car.
NA stroker BB2 commuter.
i usually use a long angle iron with 2 holes drilled in it, so i bolt the angle iron to the flywheel with a pair of pressure plate bolts. that way i i have great levereage for breaking the flywheel bolts loose.
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.