i spun a rod bearing....is it possible to fix
05-10-2004, 09:19 PM
#1
Thread Starter
Join Date: Mar 2004
Location: SoCAL, usa
Posts: 542
Likes: 0
Received 0 Likes
on
0 Posts
i spun a rod bearing....is it possible to fix
i have an h22a4 and i spun a rod bearing...it does not look to bad... i am just wondering if the crank could get turned and buy new rod bearings?
05-11-2004, 03:51 AM
#2
Junior Member
Join Date: Jan 2004
Location: Sharpsburg, GA
Posts: 431
Likes: 0
Received 0 Likes
on
0 Posts
Re: i spun a rod bearing....is it possible to fix (eduardo)
It is possible. You'll just have to take it to the machine shop and let them see if they can fix it. I've had quite a few fixed, but my lude crank was beyond repair. And it didn't look that bad.
05-11-2004, 12:13 PM
#4
Join Date: Aug 2002
Location: Birmingham, AL, USA
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Re: i spun a rod bearing....is it possible to fix (eduardo)
I tried to get a '99 crank turned but they melted it. Not sure who's fault that was, though... 
What year is your car? I have a '95 H22 crank sitting in my shop I need to part with if you can use it and / or wind up needing one...
What year is your car? I have a '95 H22 crank sitting in my shop I need to part with if you can use it and / or wind up needing one...
05-11-2004, 04:34 PM
#5
Member
Re: i spun a rod bearing....is it possible to fix (Nocturnal)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Nocturnal »</TD></TR><TR><TD CLASS="quote">I tried to get a '99 crank turned but they melted it. Not sure who's fault that was, though...
What year is your car? I have a '95 H22 crank sitting in my shop I need to part with if you can use it and / or wind up needing one...</TD></TR></TABLE>
it probably won't fit...but maybe it's a 97
What year is your car? I have a '95 H22 crank sitting in my shop I need to part with if you can use it and / or wind up needing one...</TD></TR></TABLE>
it probably won't fit...but maybe it's a 97
Trending Topics
05-15-2004, 04:19 AM
#8
Junior Member
Join Date: Jan 2004
Location: Sharpsburg, GA
Posts: 431
Likes: 0
Received 0 Likes
on
0 Posts
Re: (vinuneuro)
The actual machine shop doesn't charge that much. I think it was about $150 for the last crank I had done. The only bad part is that the entire motor has to be torn down to do it. So if you are not doing it yourself it can get costly.
05-15-2004, 03:05 PM
#10
Junior Member
Join Date: Jan 2004
Location: Sharpsburg, GA
Posts: 431
Likes: 0
Received 0 Likes
on
0 Posts
Re: (Matgallis)
Unfortunately it cannot be done without removing the tranny and flywheel. There is a housing for the rear main seal and front main seal that must be removed to remove the crank. I have done just the crank and left the pistons in place, but it still required removing the motor due to the rear main seal housing.
Thread
Thread Starter
Forum
Replies
Last Post
