Question on crx si roof drain tubes
#1
Thread Starter
Join Date: Oct 2006
Location: Vancouver, WA, USA
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Question on crx si roof drain tubes
Well, to start off I have a 89 crx si. I have been noticing that I have a leak by the struts for the hatch. I know the drain tubes are clogged and think the water is bypassing the tube in order for it to be leaking where it is. but how would I go about clearing them out without taking out the head liner? I know I need to use compressed air as well. thanks in advance and if any of it does not make sense let me know and ill clear things up.
Edit: drain tubes for the sunroof.
Edit: drain tubes for the sunroof.
#2
Honda-Tech Member
Join Date: Feb 2002
Location: Florida, USA
Posts: 1,889
Likes: 0
Received 0 Likes
on
0 Posts
more than likely the drains are clogged at end of the tube. If you open your hatch and look inside by the to either side you will see where you can remove the plasti pieces. Once you remove the piece you will see the tube running through there. You can pull the tube out and you will see it has a little nipple on the end of it more than likely it will be clogged you can just clean it.
Matt
Matt
#5
Member
Join Date: Jun 2005
Location: Northern, CA, usa
Posts: 2,458
Likes: 0
Received 0 Likes
on
0 Posts
Re: (soon to be boosted ZC)
i cleaned mine out last year. it would leak into the rear trunk area, between the fenderwell and tailight area on the floor of the trunk. mine were really clogged. i just cleaned it out and used really hot water and a screwdriver to clear out some of the mud on the lower part of the drain tube. worked out well.
#6
Honda-Tech Member
Join Date: Feb 2002
Location: Florida, USA
Posts: 1,889
Likes: 0
Received 0 Likes
on
0 Posts
yes it would leak when it was clogged.
Also if you are having problems with a leak yuou might need to pull out your rear window squirter and put some sealant on it and then re-install.
Matt
Also if you are having problems with a leak yuou might need to pull out your rear window squirter and put some sealant on it and then re-install.
Matt
#7
Re: (insomniac791)
when i removed the rear interior panels on my car the damn things weren't even plugged in,so all the water was just sitting in the crease for the 1/4 panel,,rusting it inside out..it must have been like that for years
Thread
Thread Starter
Forum
Replies
Last Post
ITR0529
Honda CRX / EF Civic (1988 - 1991)
6
12-29-2006 07:00 PM
OldSchoolCrxSiR
Honda CRX / EF Civic (1988 - 1991)
2
12-10-2002 06:30 PM