Passing Emissions (Ontario Drive Clean) help
#1
Passing Emissions (Ontario Drive Clean) help
So! my build is done and I'm ready to finally get it on the road. Besides the safety I have to get the emissions tested.
I have a D16A6 block with a D16Y8 mini-me head swap. Running 320cc bosch injectors, a magnaflow high flow catalytic converter and I have a chipped basemap P28 ECU (OBD1 conversion) with a turbo setup (don't think this is even relevant, not like an emissions test goes into boost)
Was wondering if anyone has a similar setup and has experience with emissions pass/fail, stories, tips or advice. I have ordered a stock map for the P28 (because the basemap is running rich and o2 disabled in open loop) which I plan on using and possibly putting the stock 240cc fuel injectors back in for the test (or if I even need this?)
Basically it is a 2-speed idle test, I am hoping it will pass this is the only obstacle preventing me from getting my car on the road.
Thanks
I have a D16A6 block with a D16Y8 mini-me head swap. Running 320cc bosch injectors, a magnaflow high flow catalytic converter and I have a chipped basemap P28 ECU (OBD1 conversion) with a turbo setup (don't think this is even relevant, not like an emissions test goes into boost)
Was wondering if anyone has a similar setup and has experience with emissions pass/fail, stories, tips or advice. I have ordered a stock map for the P28 (because the basemap is running rich and o2 disabled in open loop) which I plan on using and possibly putting the stock 240cc fuel injectors back in for the test (or if I even need this?)
Basically it is a 2-speed idle test, I am hoping it will pass this is the only obstacle preventing me from getting my car on the road.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
jetspeedz
Engine Management and Tuning
5
08-10-2009 10:34 AM