Mpfi swap problems please help!!! PLEASE I NEED MY CAR FIXED!
#1
Trial User
Thread Starter
Join Date: Dec 2011
Location: Calhoun,GA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Mpfi swap problems please help!!! PLEASE I NEED MY CAR FIXED!
ok guys i have a 88 ef sedan lx i just converted to mpfi and obd1 I have checked my wiring and can't figure out my problem it seams to run decent at low RPM's around 3k. But if i get over that it starts like falling on its face like stops pulling it backfires and shuts off I'm throwing a code 4, code 7, code 9, and code 15. I've tried 2 new distributors and still does the same thing. Can someone please give me some idea's. Thanks for any help that I recieve.
Code 4 Crank position sensor
Code 7 Throttle position sensor
Code 9 No.1 cylinder position sensor
Code 15 Ignition output signal
Code 4 Crank position sensor
Code 7 Throttle position sensor
Code 9 No.1 cylinder position sensor
Code 15 Ignition output signal
#2
Re: Mpfi swap problems please help!!! PLEASE I NEED MY CAR FIXED!
I would recheck your MPFI wiring conversion and check your mechanical timing along with the ignition timing since you've replaced the distributor twice.
#3
Honda-Tech Member
Join Date: Nov 2011
Location: Baltimore MD
Posts: 437
Likes: 0
Received 0 Likes
on
0 Posts
Re: Mpfi swap problems please help!!! PLEASE I NEED MY CAR FIXED!
Ive searched but cannot come up with detailed discription (pictures included) about how to do the DPFI>MPFI>Obd-1 swap. Anyone? Sorry to highjack back on topic.... Id check your distributor wiring again....
#4
Re: Mpfi swap problems please help!!! PLEASE I NEED MY CAR FIXED!
There's a guy that literally just posted up a DPFI to MPFI guide. OBD1 conversion you can buy wiring harness connecters for the dizzy.
https://honda-tech.com/forums/honda-crx-ef-civic-1988-1991-3/my-dpfi-mpfi-writeup-2994327/
http://hondaswap.com/swap-articles/d...writeup-49557/
http://www.google.com/#sclient=psy-a...w=1366&bih=595
https://honda-tech.com/forums/honda-crx-ef-civic-1988-1991-3/my-dpfi-mpfi-writeup-2994327/
http://hondaswap.com/swap-articles/d...writeup-49557/
http://www.google.com/#sclient=psy-a...w=1366&bih=595
#5
Trial User
Thread Starter
Join Date: Dec 2011
Location: Calhoun,GA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Re: Mpfi swap problems please help!!! PLEASE I NEED MY CAR FIXED!
Ok guys I'm only getting a code 4 when i go to get on my car it cuts out and pops really bad will not pull
#6
Honda-Tech Member
Re: Mpfi swap problems please help!!! PLEASE I NEED MY CAR FIXED!
I'd say the problem must be in your wiring since the cps is located inside your distributor and you say you've tried 2 other good distributors and get the same results. Double check your wiring to your distributor. What ecu and distributor are you running?
Trending Topics
#10
Trial User
Thread Starter
Join Date: Dec 2011
Location: Calhoun,GA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Re: Mpfi swap problems please help!!! PLEASE I NEED MY CAR FIXED!
yes c1 and c2 to b10 and b12 then run two wires from c1 and c2 to the wire on the dizzy
Thread
Thread Starter
Forum
Replies
Last Post
scottso990
Honda CRX / EF Civic (1988 - 1991)
10
08-02-2010 12:54 PM