Head warpage how much is too much
06-01-2005, 12:04 PM
#1
Thread Starter
Join Date: Mar 2005
Location: phoenix, az, 85051
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Head warpage how much is too much
I have a 90 crx hf that just blew a head gasket how much warpage on the head is too much, with a straight edge .013 mm is the warpage, I think its too much but just let me know.
Thanks
Randy
Thanks
Randy
06-01-2005, 12:59 PM
#3
Honda-Tech Member
Re: Head warpage how much is too much (illcrx)
helms says:
cylinder head:
.05mm-.20mm requires resurfacing
engine block:
.07mm is new. .10mm service limit.
id say you need to mill it....
cylinder head:
.05mm-.20mm requires resurfacing
engine block:
.07mm is new. .10mm service limit.
id say you need to mill it....
06-02-2005, 04:41 AM
#5
Honda-Tech Member
Re: Head warpage how much is too much (illcrx)
Before you do anything, you should take out the rocker arms and install the cams with the cam bearings. Make sure that the cam is not binding due to the warpage. If it is, get a new or used head. You might want to get a new head anyway if you can find one cheap.
06-02-2005, 11:50 AM
#6
Banned
Join Date: Jun 2005
Location: Im on the left......, Michigan
Posts: 367
Likes: 0
Received 0 Likes
on
0 Posts
Re: Head warpage how much is too much (StorminMatt)
if you dont get it reserfised your are going to not have a good tight seal (head to block) so yes get it reserfised. 
Thread
Thread Starter
Forum
Replies
Last Post
bmg123
Honda CRX / EF Civic (1988 - 1991)
7
02-07-2010 07:20 AM
