engine wont crank by hand when i install transmission
#1
Honda-Tech Member
Thread Starter
Join Date: Jan 2014
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
engine wont crank by hand when i install transmission
My engine is out of the vehicle, and spins freely when the transmission is not attached. I attach the tranny all the way in, then tighten the bolts from trsnny to engine securely, so everything lines up. After that I can't rotate the crank by hand.
- my tranny input shaft spins by hand when I twist it.
Is the flywheel suppose to spin freely , with the clutch and pressure plate on? I can't spin it by hand or with a screw driver or anything.
- my tranny input shaft spins by hand when I twist it.
Is the flywheel suppose to spin freely , with the clutch and pressure plate on? I can't spin it by hand or with a screw driver or anything.
#2
PHANTOM MENACE
iTrader: (2)
Join Date: May 2005
Location: SYCUAN NINE, CA, USA
Posts: 6,042
Likes: 0
Received 3 Likes
on
3 Posts
Re: engine wont crank by hand when i install transmission
I've never tried this but taking a random stab at your situation. Actuate the clutch lever. Maybe the disc is clamped off center at the moment.
#3
Honda-Tech Member
Re: engine wont crank by hand when i install transmission
(not talking about transmission yet)
#4
Honda-Tech Member
Thread Starter
Join Date: Jan 2014
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
Re: engine wont crank by hand when i install transmission
I got it to turn, I think the first time I put it in... It must have not pushed all the way through or something; think I forced it at a weird angle, but nothing looks damaged. The second time I installed the transmission I used my hoist to ease it in.
Thread
Thread Starter
Forum
Replies
Last Post
CleanLikeJdm
Acura Integra
10
02-11-2005 05:36 PM