d16a6 (Si) motor electrical sensor questions
#1
Honda-Tech Member
Thread Starter
Join Date: Jan 2002
Location: USA
Posts: 2,091
Likes: 0
Received 0 Likes
on
0 Posts
d16a6 (Si) motor electrical sensor questions
If you are looking at the CRX SI motor from the BACK (staring at the intake manifold) there are four electrical sensors. Going from left to right I believe they are:
air temp sensor (left side of intake manifold), tandem valve control solenoid valve, electronic air control valve, then throttle position sensor (far right).
Is this correct?
air temp sensor (left side of intake manifold), tandem valve control solenoid valve, electronic air control valve, then throttle position sensor (far right).
Is this correct?
#3
Honda-Tech Member
Thread Starter
Join Date: Jan 2002
Location: USA
Posts: 2,091
Likes: 0
Received 0 Likes
on
0 Posts
Re: d16a6 (lelopez)
thanks lelopez. then I have a new question.
Doing a DX to Si DPFI to MPFI swap and there is no plug on the DX wiring harness that will plug into the SI tandem valve control solenoid valve. Is this sensor not necessary?
Doing a DX to Si DPFI to MPFI swap and there is no plug on the DX wiring harness that will plug into the SI tandem valve control solenoid valve. Is this sensor not necessary?
Thread
Thread Starter
Forum
Replies
Last Post
ijjz
Honda CRX / EF Civic (1988 - 1991)
2
03-25-2004 08:28 PM