D-series with equal length half-shafts
#1
Honda-Tech Member
Thread Starter
Join Date: Sep 2004
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
D-series with equal length half-shafts
I'm trying to figure out which D series tranny I can use to have equal length half shafts...
I know the DOHC ZC tranny uses equal-length half shafts.
Problem is that not all D series blocks have holes in them for the midshaft support bearing.
So I'm wondering if there's any other D series blocks with bolt holes for the midshaft support, or any other D series transmissions other than the DOHC ZC with equal length half shafts.
I found this:
http://cgi.ebay.com/ebaymotors...wItem
It's an auto tranny with equal length half shafts on a SOHC non-vtec ZC block. So do all ZC blocks have the bolt holes?
I can't find much info at all on this.
I know the DOHC ZC tranny uses equal-length half shafts.
Problem is that not all D series blocks have holes in them for the midshaft support bearing.
So I'm wondering if there's any other D series blocks with bolt holes for the midshaft support, or any other D series transmissions other than the DOHC ZC with equal length half shafts.
I found this:
http://cgi.ebay.com/ebaymotors...wItem
It's an auto tranny with equal length half shafts on a SOHC non-vtec ZC block. So do all ZC blocks have the bolt holes?
I can't find much info at all on this.
#7
Honda-Tech Member
Join Date: Jun 2005
Location: 818, CA, USA
Posts: 983
Likes: 0
Received 0 Likes
on
0 Posts
Re: (SiRay13)
I think its the 1.6 blocks that have the holes tapped. The 1.5s have holes too but they arent tapped...just tap the holes on your B2 and throw the ZC tranny on and itll work.
Trending Topics
#8
Honda-Tech Member
Join Date: Sep 2002
Location: colorado springs, co, usa
Posts: 5,643
Likes: 0
Received 28 Likes
on
28 Posts
Re: (silentdork818)
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by silentdork818 »</TD></TR><TR><TD CLASS="quote">I think its the 1.6 blocks that have the holes tapped. The 1.5s have holes too but they arent tapped...just tap the holes on your B2 and throw the ZC tranny on and itll work.</TD></TR></TABLE>
D15 blocks do not have the holes for the intermediate shaft
D15 blocks do not have the holes for the intermediate shaft
Thread
Thread Starter
Forum
Replies
Last Post