Cutting one piece AEM CAI to install bypass valve?
06-27-2007, 08:54 AM
#1
Honda-Tech Member
Thread Starter
Join Date: Sep 2002
Location: San Antonio, TX
Posts: 198
Likes: 0
Received 0 Likes
on
0 Posts
Cutting one piece AEM CAI to install bypass valve?
Just wanted to ask if anyone has cut into two pieces a one piece AEM intake...
Since I moved from San Diego to San Antonio I didnt relize that the roads and rains here are alot more frequent and deeper. My concern is hydrolocking my motor since my rex is lowered and im running the CAI.
I was thinking of buying the bypass vavle, but my concern is cutting the intake.
Has anyone done this? Also what did you use to cut it/ was is a clean cut without destorying the chrome finish?
Thanks,
Mig
Since I moved from San Diego to San Antonio I didnt relize that the roads and rains here are alot more frequent and deeper. My concern is hydrolocking my motor since my rex is lowered and im running the CAI.
I was thinking of buying the bypass vavle, but my concern is cutting the intake.
Has anyone done this? Also what did you use to cut it/ was is a clean cut without destorying the chrome finish?
Thanks,
Mig
06-27-2007, 10:14 AM
#2
Honda-Tech Member
Re: Cutting one piece AEM CAI to install bypass valve? (Silver_Rex)
ive used rotary cut off wheels.
tape off the edges and follow the line to keep it straight. or, same method with a hacksaw.
tape off the edges and follow the line to keep it straight. or, same method with a hacksaw.
06-27-2007, 09:46 PM
#4
Honda-Tech Member
Re: Cutting one piece AEM CAI to install bypass valve? (Silver_Rex)
no problem.
just take it slow and be patient, it'll come out a clean cut. dont rush it.
just take it slow and be patient, it'll come out a clean cut. dont rush it.
Thread
Thread Starter
Forum
Replies
Last Post
