RanCRX

Howdy,

I searched google as best as I could for DIY but to no avail. I decided to do a few things to the car dealing with removing the tranny and I'm having problems hooking up the rear mount k bracket to the transmission reinstalling.

Before removal I had passenger, driver and rear mounts installed. To remove the Tranny, I removed the bolts off the tranny side of the k bracket rear mount, and totally removed the passenger mount off the tranny. Leaving the driver mount alone. Which is the setup now installing the tranny back.

I have the drivers axle removed with the intermediate shaft. The car is lifted by two jack stands in the front and enough space in the bottom. The engine is angled down towards the passenger side floor.

Any advice and recommendations on installing the rear mount bracket? It's not very flexible. Do I install the k bracket first before mating to the block or after? Both seem difficult to do, at least by myself. I can get a helping hand.

Any help gladly appreciated

v4lu3s

bolt to engine use a jack to raise engine and transmission to bolt the rear mount bracket.


Posted from Honda-tech.com App for Android