H22A1allmotor

I am putting a B16A2 into a 1990 civic wagon and i have read all through the archives and i still do not understand this so please help me understand. The B16 has an electronic speed sensor at the trans, and my trans now is cable operated. I want to still have my speedometer work after the swap, so do i change the sensor on the B16 trans to a cable type(and what sensor can i use to convert my B16 trans to cable)? And if i do this will vtec still engage? i thought that the ecu needed to see engine speed above 17mph before vtec would engage. I am using an obd0 to obd1 conversion harness in order to still use my stock harness. I know you guys might have answered this before but i cannot find anything answering these questions and i am still confused about all of it.

Magick211

well you can use a cable type vss in the hydro tranny. Or you can use the electronic vss and convert to a guage cluster that uses electronic vss

NKSforever

..

H22A1allmotor

so if i use the cable type in the hydro tranny then vtec will still work? and it works because the cluster sends a speed signal to the ecu?

Pee Wee

do u still have the old tranny. i assume it was out of a d series. if so u can use that one i did.

surkitroller

yes i do still have the trans but it is a 4 wheel drive trans, does ths make any difference?

Pee Wee

i think so, not sure though. i was told any d series will fit any b series.


Modified by opey'scrx at 9:09 AM 8/5/2005