hondachris1994

when I point my timing light on the crank pulley, there is 3 lines. The line all the way to the left is where the mark on the timing belt cover is pointing at...is that correct?

hondachris1994

any 1 have a link for this?

superfast666

there should be 3 lines really close together the correct timing would be the middle mark it should be red

hondachris1994

I shot my timing and its on the left line, but I also have motor work done, so is this okay or does it need to b in the middle line?

hondachris1994

bump for some info

jime64871

iTrader: (1)

depends what kind of motor work did you have?
more info would help...

thesmogman

You should line up the middle mark of the three. The middle mark is your spec. and the outer two are a reference to the alotted 2 degrees you can be off. So the outer marks are + or - 2 degrees from your spec.

The white mark is the TDC mark and if you have an advance-able timing light you can dial up the spec degree on the light and it should show you the white TDC mark. This is a way to double check your setting.

jime64871

iTrader: (1)

best advice you'll get, right there ^
regarding timing..