Rear Sway bar question on 95 Honda Civic DX (Ej2) - Chassis mounting holes no thread!
#1
Honda-Tech Member
Thread Starter
iTrader: (1)
Join Date: Nov 2002
Location: Firefox4life, So CA
Posts: 7,703
Likes: 0
Received 0 Likes
on
0 Posts
Rear Sway bar question on 95 Honda Civic DX (Ej2) - Chassis mounting holes no thread!
Hey, I just installed some integra rear lcas and the bolts and endlinks on my 95 Honda Civic but however, the holes on the subframe dont have any threads? How do you get the bar to mount to the subframe? Does it use some nuts on the other side of the bolts?
Thanks,
Jon
Thanks,
Jon
#4
Honda-Tech Member
Join Date: Oct 2005
Location: State College, Pa, US
Posts: 2,309
Likes: 0
Received 0 Likes
on
0 Posts
Re: Rear Sway bar question on 95 Honda Civic DX (Ej2) - Chassis mounting holes no thread! (CRX-Fluff
You might want to add some washer behind the sub-frame to give the sheet metal a little more support
#5
Honda-Tech Member
Thread Starter
iTrader: (1)
Join Date: Nov 2002
Location: Firefox4life, So CA
Posts: 7,703
Likes: 0
Received 0 Likes
on
0 Posts
Re: Rear Sway bar question on 95 Honda Civic DX (Ej2) - Chassis mounting holes no thread! (CRX-Fluff
The mounting plates for the sway bar I do have. I will have to go ahead and put more washers on the other side of the subframe. Geez, its hard to use the wrench to hold the nut to tighten the sway bar to the subframe.
Thread
Thread Starter
Forum
Replies
Last Post