Oil control orifice question
01-19-2007, 10:39 PM
#1
Thread Starter
Join Date: Nov 2005
Location: Beaverton, or, usa
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
Oil control orifice question
I have a 94 JDM B18C and i replaced the cams and gears. once installed i timed everything and adjusted everything. One thing also did was clean off the gunked up intake and exhaust oil control orifice's and i put them back in the correct sides they came from but didnt take it mind what direction the holes were pointing. i then reasembled everything and drove it. Vtec pops on but doesnt fully engage.
My question is do i have to pull everything out of the head like the rocker arms and shafts and then put the orifices in and then reasemble everything or is their a certain angle the holes are supposed to be angled at?
thx chris
My question is do i have to pull everything out of the head like the rocker arms and shafts and then put the orifices in and then reasemble everything or is their a certain angle the holes are supposed to be angled at?
thx chris
Thread
Thread Starter
Forum
Replies
Last Post
