2k_Si

i just finish painting my valve cover. i have an all new gasket set ready to install. do i need honda bond in the flat spots by the cams and vtec solenoid? or will i be fine with out any? thanks in advance

Juan_Mitosis

In any case, just to have the gasket sit still while putting the cover back. But having a tube of honda bond around is pretty much a MUST HAVE if you plan on doing many D.I.Y.

steveo135

got myself a tube

I would suggest it if your installing a new gasket... but you can always wing it and see what happens

2k_Si

would this be ok to use

Targa250R

Gray RTV will work in a pinch. You just need a small dab at any "corners" on the gasket, i.e. the angle on each side of each cam hump.

I use Honda Ultra Flange Sealant myself. Comes in a bigger tube than Hondabond HT and works the same.

2k_Si

thank you H-T. i will be going to oreilys tomorrow. i was hoping to finish my weekend project, but i dont want to cut corners

wite2nr

yes, I just did a valve adjustment and whenever you pop off the valve cover make sure the surface is clean and free of oil, and put a strip of RTV / hondabond on the corners and by the cam

trustdestruction

It's recommended but i've never done it. No leaks here... but I could just be lucky.

steveo135

good for you... now i just wish everyone else who considers themselves a DIY'er would practice that