2000 civic si rear camber question
#1
2000 civic si rear camber question
I was installing a new skunk 2 pro series camber kit on the front and rear. on the rear, the old bolt head snapped off holding the camber arm to the frame. how should i get this out? thanks
#2
Re: 2000 civic si rear camber question
A few options.
Cut threw each side of the UCA, and pull the arm out, break the welded nut off, and try to pound the little peices left behind.
Get new bolt/nut. You can weld it back on if you please.
----
get a new trailing arm.
----
Break the welded nut off, and attempt to pound the bolt threw the bushings. Thus saving it for future use/sale.
Oh, and be thankful the welded nut inside the frame didn't break. Put antiseize on all of those bolts, now!
Cut threw each side of the UCA, and pull the arm out, break the welded nut off, and try to pound the little peices left behind.
Get new bolt/nut. You can weld it back on if you please.
----
get a new trailing arm.
----
Break the welded nut off, and attempt to pound the bolt threw the bushings. Thus saving it for future use/sale.
Oh, and be thankful the welded nut inside the frame didn't break. Put antiseize on all of those bolts, now!
Thread
Thread Starter
Forum
Replies
Last Post
endwell17
Honda Civic / Del Sol (1992 - 2000)
1
10-05-2013 07:13 PM
jdurston
Suspension & Brakes
7
02-19-2006 08:07 AM