Electrical/Wiring Question On 99-00 EK Power Windows.
#1
Junior Member
Thread Starter
Join Date: Sep 2006
Location: Ontario, California
Posts: 618
Likes: 0
Received 0 Likes
on
0 Posts
Electrical/Wiring Question On 99-00 EK Power Windows.
OK, I have A 2000 EK and im installing the power windows in my car, Yes I've searched it and Yes im using the wiring diagrams/pictures that some fellow H-Ter's provided. The parts im using are from a 00 Si, if that makes a difference. Anyways I made my own custom wiring and have everything working properly (The drivers side controls the passanger side/ Etc) EXCEPT I dont know how to hook up the drivers Side Automatic Window Up/Down Thingy. I ran the wires like this:
Power -> Red Wire
Ground -> Yellow Wire
Then I have two wires left (Which control the auto up/down feature) They are a thin black wire and a thin light blue wire.
So my question is I dont care about getting the auto up/down feature working. I just want the drivers side window to roll up and down. Basically I just want to disable/bypass the auto up/down feature. So do i ground the two left over wires or do I connect them together or do I seperate them and Just wrap the ends with Electrical Tape or what? I dont want to try and hook it up and then fry the motor. Please help!
Also Im not using the control unit in the picture below.
Please don't reply if your going to tell me: Just Get The Floor Harness/Right Parts...Cause Your Not Going To Help!
Modified by Type Ek at 1:11 AM 11/21/2006
Power -> Red Wire
Ground -> Yellow Wire
Then I have two wires left (Which control the auto up/down feature) They are a thin black wire and a thin light blue wire.
So my question is I dont care about getting the auto up/down feature working. I just want the drivers side window to roll up and down. Basically I just want to disable/bypass the auto up/down feature. So do i ground the two left over wires or do I connect them together or do I seperate them and Just wrap the ends with Electrical Tape or what? I dont want to try and hook it up and then fry the motor. Please help!
Also Im not using the control unit in the picture below.
Please don't reply if your going to tell me: Just Get The Floor Harness/Right Parts...Cause Your Not Going To Help!
Modified by Type Ek at 1:11 AM 11/21/2006
#2
Junior Member
Thread Starter
Join Date: Sep 2006
Location: Ontario, California
Posts: 618
Likes: 0
Received 0 Likes
on
0 Posts
For anyone that runs into this problem the answer would be just seperate the two wires and wrap them with electrical tape!
Modified by Type Ek at 11:03 AM 11/22/2006
Modified by Type Ek at 11:03 AM 11/22/2006
Thread
Thread Starter
Forum
Replies
Last Post