ECU problem for the best techers!
#1
Thread Starter
Join Date: Aug 2003
Location: Mad City, WI
Posts: 625
Likes: 0
Received 0 Likes
on
0 Posts
ECU problem for the best techers!
My ECU won't reset. Tried the negative terminal, the 15 amp, th 7.5 amp. Tried all of them in any combination you can think of, and the ECU will not reset.
Burnt a p30 map onto p28 with uber, running a little rich, but triggered no CEL. was going to tune with wideband so plugged in ostrich with the same map, tapped up the wideband and CEL triggered. Limp mode. I pulled the code 41 and reset it, then took off the ostrich and plugged in the original map. CEL triggered again. Now I can't reset, nor can I pull codes. I tap in grey plugs the exact same way that I always do, and nothing... CEL just stays solid, and it won't reset. Any suggestions will help.
Burnt a p30 map onto p28 with uber, running a little rich, but triggered no CEL. was going to tune with wideband so plugged in ostrich with the same map, tapped up the wideband and CEL triggered. Limp mode. I pulled the code 41 and reset it, then took off the ostrich and plugged in the original map. CEL triggered again. Now I can't reset, nor can I pull codes. I tap in grey plugs the exact same way that I always do, and nothing... CEL just stays solid, and it won't reset. Any suggestions will help.
#3
Thread Starter
Join Date: Aug 2003
Location: Mad City, WI
Posts: 625
Likes: 0
Received 0 Likes
on
0 Posts
Re: (schardbody)
41 is a primary o2 heater. how would i have fried the ecu. it still starts and runs, just rich as **** ( wideband reading 10's -11's at idle) just can't reset it or pull code anymore....
Thread
Thread Starter
Forum
Replies
Last Post
justseeingifitistaken
Honda CRX / EF Civic (1988 - 1991)
9
11-22-2006 06:21 PM