started polishing it but dont know how to get between the HONDA lettering w/ sandpaper. by the way i am starting with 150fine then 220 extra fine then 400 some one said i had to wet the paper? i dont know, but i cant get all the grime that dripped down from the plug holes. oh and i got some generic multy meytal polosh too, anything else work better? or any pics?
you should strip it, then sand it with a soap/ water mix with a really high grit paper. I believe you should end up using a 1500 or 2000 paper in the end. That is what i have found as far as polishing.
ah ha! I remember now! Aircraft remover, yes it actually says that, (WalMart)... garanteed to rid your yard of 747s and get the paint off your valve cover. Only use 800-1500, and even 2000 if you have patience. Lower grit than that and you'll scar the metal.
A polishing wheel with some good hard compound is a must. Sears can help you out in this area.
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.