Story: I was going back to my car, got in, started up the engine and rolled down my windows. I noticed that it wont roll down and it was making some sort of ticking noise. I pressed down again and the window rolled ALL THE WAY DOWN. Now I cant roll it back up. When I press the roll down button, this black wire comes out. Wtf is going on? How do I remove the door panels so that I can see what the heck is going on?
if its anything like my car which it may or may not be the actual door handle slides back and comes out after you take the screw out then the door panel will pop off after you take out the screw under the cap in the armrest inside the hand hold. if that all makes sense haha. there may be other screws too just look for caps.
1991 Honda Accord LX
17" Konig Monsoons
future plans: full adjustable coilovers, probably h22 swap, new paint, full headers and exhaust, much much more
1 screw is under a plastic cover in the handle
1 screw is under the mirror control on that vinyl handle
1 screw is under a cover at the base of that handle where it meets the door
1 plastic screw is at the top below the mirror cover
pop out mirror cover (couple clips, pull out and up)
take off speaker grille
wedge fingers in between panel and metal and start tugging outwards, there's ~15 clips around the door
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.