You are currently viewing our forums as a guest, which gives you limited access to view most discussions and access our other features. By joining our community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join the Honda-Tech community today!
At Clutch pressure solenoid re-install issue 99 accord ex v6
I have a 99 accord ex v six. I removed and cleaned and tested the the lockup A and B solenoid and screens. The C and D solenoids. On the Clutch Pressure Solenoid. When removing I pulled out the three tubes and o rings that go through the gasket. I did not look at the orientation of the tubes when I did this. On one end of the steel tubes they have a type of flare on the other end of the tube they are slightly tapered. Does anyone know which end of the tubes go up into the solenoid body and which goes down into the tranny body
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.