Clutch Master Cylinder Installation; Stream Of Fluid, No Compression On Clutch
#1
Clutch Master Cylinder Installation; Stream Of Fluid, No Compression On Clutch
I got a '95 Accord EX 2.2 5-speed and just replaced the clutch slave cylinder and master cylinder and put my finger over the plug extremely tight and bled it multiple times, then bled normally. We're getting nothing but fluid shooting out, but there is no compression on the clutch whatsoever and it's sticking on the floor. I have to use my hand to pull it back up to pump it. We're on our last nerve, taking a break, and I really need your guys advice? We were told there's some kind of special way to bleed a clutch master cylinder after bench bleeding, but not sure. PLEASE ADVISE.
#2
Re: Clutch Master Cylinder Installation; Stream Of Fluid, No Compression On Clutch
Figured it out. If you're installing a clutch master cylinder, before you waste half a gallon of brake fluid, ADJUST YOUR PUSH ROD!
Thread
Thread Starter
Forum
Replies
Last Post
mikep_95133
Honda Accord (1990 - 2002)
2
12-22-2013 12:35 AM