97 Honda Accord LX Driver's Window
#1
97 Honda Accord LX Driver's Window
I apologize if this has already been posted but I need help.
Before I get into detail my main window switch (on driver's sides) rolls up and down my back window seats, on my passenger window i can only roll the window down but not up. My driver window i was able to roll up and down until recently.
Recently I rolled down my driver's side window and now my window is stuck. I can't roll it back up. I was told it was maybe the motor/regulator. So i bought a new one and installed it yet I still can't roll my window up.
I'm not very car savy.....please help
Before I get into detail my main window switch (on driver's sides) rolls up and down my back window seats, on my passenger window i can only roll the window down but not up. My driver window i was able to roll up and down until recently.
Recently I rolled down my driver's side window and now my window is stuck. I can't roll it back up. I was told it was maybe the motor/regulator. So i bought a new one and installed it yet I still can't roll my window up.
I'm not very car savy.....please help
#3
Re: 97 Honda Accord LX Driver's Window
Test the switch....many times these can be cleaned and get them back to working.
If you pull the switch try this.
Drivers window up: Jump these wires
GRN/WHT to RED/YEL (1)
RED/BLU (1) TO BLK
Drivers window down: reverse the jump like this
GRN/WHT TO RED/BLU
RED/YEL TO BLK
Pass Frt up: Jump these
BLU/YEL TO BLK
BLU TO BLU/BLK
Pass Frt down: again reverse like this
BLU/BLK TO BLU/YEL
BLU TO BLK
Then you can transfer where these wires connect to the switch and check for continuity on the pins of the switch to see if it is there. If it is not then again I would try to clean the contacts un the toggle to see if that gets it going......or replace the switch.
If you pull the switch try this.
Drivers window up: Jump these wires
GRN/WHT to RED/YEL (1)
RED/BLU (1) TO BLK
Drivers window down: reverse the jump like this
GRN/WHT TO RED/BLU
RED/YEL TO BLK
Pass Frt up: Jump these
BLU/YEL TO BLK
BLU TO BLU/BLK
Pass Frt down: again reverse like this
BLU/BLK TO BLU/YEL
BLU TO BLK
Then you can transfer where these wires connect to the switch and check for continuity on the pins of the switch to see if it is there. If it is not then again I would try to clean the contacts un the toggle to see if that gets it going......or replace the switch.
Thread
Thread Starter
Forum
Replies
Last Post
condor22
Honda Accord (1990 - 2002)
3
12-30-2014 06:35 AM