F22A6 intake manifold
#2
Honda-Tech Member
Re: F22A6 intake manifold
If you want the secondary butterflies (IAB) to run via electronic control, then yes you need the PT6. However, if you remove the secondary butterflies or run them with a mechanical/vacuum, then you won't need the PT6 ECU.
#5
Honda-Tech Member
Re: F22A6 intake manifold
If your going to run the PT6 you could wire up the IAB solenoid. The wire runs from the solenoid to Pin A17 on the PT6 ECU. Other than that remember your ground connections.
#6
Re: F22A6 intake manifold
I have the same motor and doing the same thing and was just wondering if you remove the second set of flaps on the intake manifold would you still get the normal preformance out of it. And also can I swap out a prelude ecu from a f22a1 and do better than the accord ecu
Thread
Thread Starter
Forum
Replies
Last Post