b20z b20b vtec b16 head skunk2 itr manifold weisco pistons forged rods

Closed Thread Subscribe

Thread Tools

Search this Thread

08-01-2006, 10:36 PM

quick1racer

Thread Starter

Join Date: Oct 2003

Location: orange county, ca, usa

Posts: 354

Likes: 0

Received 0 Likes on 0 Posts

b20z b20b vtec b16 head skunk2 itr manifold weisco pistons forged rods

trying for the last time to sell my b20z vtec build i have had in my garage for the last year. the engine is assembled as of right now and it has zero miles i would prefer to sell the motor complete for 3500 but i will part it out finally make me any decent offers on the parts and the only parts i am looking for in return is a complete h22 swap with trans and ecu
so here is the build:

<U>B20z bottom end </U> stock sleeves bored and honed and decked to 84.5 by dan bensons

<U>b20z crank knife edged </U>by castillos (recommended by bensons) micropolished journals and balanced it has stock width journals (it hasn't been turned)

new type r oil pump

ACL bearings mains rods thrust

forged i beam rods with arp bolts balanced

CP (not weisco) pistons 12.3 to 1 compression 84.5 mm

new type r water pump

cometic head gasket 84.5 mm .0030 thick

b16 head skunk2 springs Ti retainers port and polish and valve job by alaniz

aebs type r style intake manifold

70mm throttle body rpm servicesd

gsr head studs arp

chrome valve cover cut to adjust gears

b16 gen 1 tranny cable clutch with richmond racing spool installed(stock open diff also included)

b series motor mounts for 91 civic

aasco light weight flywheel

act clutch in good shape

i will email any photo requests
jcab64@yahoo.com

KamiKazeEG will vouch for me

Modified by quick1racer at 7:11 PM 8/4/2006